Model #79047832405 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to repair my oven that won't heat after completing self cleaning cycle?

A:

This type of failure should have triggered an error code to help us have a direction to head into. To start out with you will need a volt/ohm meter to make some checks with. We need to know if the red wire on L2 in at the K4 relay on the control board has voltage. If we do not have voltage there then I suspect the safety thermostat has failed. If you have 120volts then I suspect the EOC electronic oven control. This could have been caused by a shorted relay on the control board. You will need to ohm out the K4 relay with your meter. If the contacts are shorted the control board will need to be replaced along with the safety thermostat.

Please see the image provided for information on accessing the oven controls.

Be sure to use extreme caution when working with live voltage & disconnect power before attempting repairs.

Read More
biker dave -
Sears Technician
October 04, 2009

Top Parts