Model #79047779400 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Upper Oven
    3 Results
  • Lower Oven
    3 Results
  • Doors
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore Double oven.. not heating

A:

It can be frustrating when the Kenmore oven does not work properly. I hope the information in the link provided below is helpful while an expert responds with additional information.

Read More
Anna T -
November 28, 2012
A:

Thank you for submitting your question. If the elements are testing good, then the issue could be with the main control board or the oven sensor temperature probe. You'll need an ohms meter to test the temperature probe to see if its faulty or not (image one). To test the sensor, remove the oven temperature sensor probe and disconnect the two wires. The temperature sensor probe is likely removable from inside the oven cavity. Remove the two screws and slowly begin pulling the sensor out until you come to a quick disconnect plug. Disconnect the sensor plug and then insert one meter lead into the terminal of the temperature sensor plug and place the other meter lead into the other terminal of temperature sensor plug. Place the dial on your multimeter to 200K as shown in the image below. The temperature sensor probe should measure 1091 ohms plus or minus 5.3 ohms at room temperature of 75 degrees plus or minus 2.5 degrees if it's okay. If it does not measure approximately 1091 ohms, replace (image two) the temperature sensor probe (316217002). If the oven temperature sensor has approximately 1091 ohms then the oven control board (316429708) will need to be replaced (image three). I hope this information helps. Please reply back to this thread if you require further assistance. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
November 29, 2012
See more answers
Q:

Why does my wall oven drip from the interior top right hand corner while baking?

A:

There is a scoop kit that can be installed in this oven by a technician that would prevent the dripping from the oven vent. The part number for the vent scoop kit is 903087-9010. Even though you could order this part from the Sears PartsDirect website, I recommend having a technician install it. This would fix the dripping problem.

Read More
Lyle W -
Sears Technician
April 22, 2009

Top Parts

Recommended maintenance parts & accessories