Model #79040453802 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

power went out. Power Came back ok on and oven beeps F13. What do I do? 79040453802 Kenmore Electric oven

A:

Hi,

I would unplug the appliance and let it set overnight. this should reset the control. If not then I would advise you to contact a technition. I found the following information on the manage my life site

On the Kenmore ranges that begin with model number 790. . ., the F13 error code does indicate that the control board will need to be replaced if the code cannot be cleared by shutting off the power and then restoring it.

Hope this helps.

Wayne.

Read More
Wayne L -
Sears Technician
November 06, 2013
Q:

the oven is actually flashing F13. It started after an outage when it came back on 79040453802 Kenmore Electric oven

A:

Thank you for choosing SearsPartsDirect.com. I am sorry to hear that your oven started acting up after and outage. I know how upsetting it must be that you have this error code. For your Kenmore Wall oven model number 79040453802, code F13 means the controls internal checksum may have become corrupted. Press CLEAR key. Disconnect the power and wait 10 seconds. If the error code returns when you power the oven back up, the electronic control needs to be replaced. I hope this helps you get your oven back up and runnging. I hope this helps! Have a great day!

Read More
Samantha A -
Sears Technician
November 05, 2013
Q:

Kenmore wall oven model # 790.40453802

A:

I think we all get a little frustrated when an appliance we depend on to cook our dinner starts acting up on us. I'm sorry to hear that you are having some issues with your Kenmore wall oven. I did some research at Managemylife website and found an expert answer to a similar question that may help until your expert can respond. I have attached the link below so you can check it out. If you are thinking about scheduling service and have a qualified technician assist you, I have also attached the link to SearsHomeServices. I hope the links below will help you out Kenneth.

Read More
James -
December 18, 2012
A:

That link for a previous answer that James posted in the above response provides an explanation for the F10 code. If that code is being displayed when the oven is at room temperature, then you may need to replace that oven temperature sensor probe in the oven. You can test that component using a volt/ohm meter before replacing parts. Shut off the house circuit breakers for the oven and access the oven temperature sensor probe as shown in the image below. (If you do not see screws on the inside of the oven cavity as shown below then that sensor will need to be accessed from the back of the oven.) Measure the resistance through that sensor using your volt/ohm meter. You should measure around 1100 ohms of resistance through that sensor at room temperature. If that resistance is over 2500 ohms then the sensor is bad and it will need to be replaced. You can order that part from this page: Oven Temperature Sensor Probe for Kenmore Wall Oven Model 790.40453802 . Be sure that you shut off the house circuit breakers for the oven before accessing internal components and replacing parts.

If that oven temperature sensor probe is okay, then you could have problem with the wiring harness or the electronic oven control board. Reply with additional details if you need more help with this problem.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 19, 2012
See more answers

Top Parts