Model #79040439800 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

kitchen wall oven 79040439800 Kenmore Electric oven

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore range.

From the information you have provided above, after researching model number 790.40439800. The lower element has two screws you will need to remove before removing the element. I have linked some information below that may help you get the element out.  Click here.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
March 04, 2015
Q:

MY OVEN JUST STARTED NOT REACHING PROPER TEMPERATURE WHEN SET. 79040439800 Kenmore Electric oven

A:

Thanks for the inquiry and for being a valued member.

I am sorry to hear of the issue you’re having with inconsistent cooking temperatures. I know how frustrating that is to have happen.

On something like this you will need to check the temp sensor with an ohm meter. If the temp sensor & harness checks out, then you will need to replace the ERC (clock). 

I recommend removing and testing the oven temperature sensor probe with an Ohm meter. At room temperature the sensor should measure approximately 1100 Ohms.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
December 09, 2014
Q:

Kenmore wall oven

A:

Power outages do play havoc on appliances. While you wait for the expert, you might check a similar question attached to the link below. I hope the suggestions in the link help.

Read More
Barbara -
September 23, 2012
A:

Thank you for your question and I understand your concern.

Based on your symptom and details it sounds like when the electricity went or back on, it may have had a power surge causing a failure within the electronic oven control/clock assembly. When the power was restored the clock should be flashing 12:00 and then you would have to press "Clock" icon and then within 5 seconds, pres and hold the up or down arrow key until the correct time of day is displayed.

If you pressed the BAKE key and "---" appeared; within 5 seconds you must press the up or down arrow key to display 350. Pressing and holding the up or down key will change the oven temperature setting. If the control will not allow you to set the clock or program and set a bake temperature, replacing the electronic oven control/clock assembly will most likely repair the failure.

The clock/oven control can be ordered from Sears Parts Direct. NOTE: Disconnect the power supply from the oven before servicing.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
September 25, 2012
See more answers

Top Parts