Model #79036902900 KENMORE Slide-In Range, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

the oven won't work 79036902900 Kenmore Gas range

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your range.  Upon researching model 79036902900; since you have already replaced the control panel, the problem of your oven not heating could be caused by a bad control board, oven temperature probe or heating element . If the oven control (timer) is responsive and appears to work fine with exception of the oven just not heating you may want to start by replacing the temperature probe since it’s the least expensive of the parts suspected to cause this problem. I have posted a link below of the temperature probe key#

I trust this information will help you, Thank you for choosing Sears.

Read More
Jeff Wallace Jr -
Sears Technician
November 28, 2014
Q:

Hanging blue wire

A:

Managemylife.com is always a great resource to find the answers to just about anything. I know this information can be very helpful for you to have. While you have been waiting for your expert to respond, I did some research but I was unable to locate information that would be helpful with regards to your question at this time. Your expert will be answering you within two business days but usually sooner. Thank you for using Manage My Life.

Read More
James -
January 04, 2012
A:

Thank you for your question and I understand your concern.

Thank you for adding an image of the disconnected blue wire. The blue wire was most likely connected to one of the 4 terminals on the oven safety valve. Look on the dual oven gas valve that you see just to the right rear in your photo that I circled in red. I also added an image of the wiring diagram of the dual oven safety valve. I believe the wire will be marked with #14 printed on it somewhere indicating where it should attach. If your not able to see a #14 on the blue wire then you will need to look on the dual safety valve for a male terminal without a wire attached and connect the blue #14 wire to that terminal. NOTE: Disconnect the power cord from the power source before reattaching the disconnected blue wire. If you do not feel confident or safe in reattaching the wire then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services or you can call 1-800-469-4663.

Read More
Joey S -
Sears Technician
January 06, 2012
See more answers

Top Parts