Model #790330020 KENMORE Counter Unit, Gas

  • Cooktop
    3 Results
  • Burner
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore gas stovetop

A:

Replacing the ignitor switch on the range could be difficult without the proper instructions. I did some research based on your question & added a link with general information. Hope this helps!

Read More
Yadira B -
November 29, 2012
A:

You will need to unplug the cooktop or shut off the house circuit breaker to disconnect electrical power . Also, shut off the gas supply to the cooktop . Remove the grates. You can then pull the cooktop out of the counter. The parts diagram pages for the cooktop are shown in the images below. You can use those images as a guide for accessing the igniter switch (Key 3 in the first image). Pull the knobs off of the burner switches. Remove the burner caps, burner heads and drip pans from the top of the cooktop. You can then remove the burner box below the cooktop. This should give to access to that burner switch.

I hope that this general information helps. If you need more assistance, reply with additional details and we will try to assist you further.

If you get to the point where you need to have a service technician replace that burner switch, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 30, 2012
A:

Thanks for advice--though I was under the impression that the ignitors were not all linked together and that I could replace them individually as only one burner is refusing to light at this point. The ceremic tip is clear of "gunk" and gas is freely flowing to it--I can manually light it with no problems.

Read More
Anonymous -
November 30, 2012
A:

That link for a previous answer that Yadira B. posted in the above response describes a range that has all of the igniter switches and the connecting wire harness as one component. Your cooktop model 790.330020 appears to have separate switches that can be replaced individually (part 318037700). Here is a direct link for that individual burner switch: Ignitor Switch . That link has a photograph of the individual burner switch. The wire harness is sold separately from the burner switch on this cooktop. I hope that this additional information helps. If you need more assistance, let us know.

Read More
Lyle W -
Sears Technician
November 30, 2012
See more answers

Top Parts