Model #79031073100 KENMORE ELITE Slide-In Range, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Oven beeping every 10 minutes 79031073100 Kenmore Elite Gas range

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your range oven and I do understand your frustration. Glad to help out. I'm looking at your model number 79031073100 and this failure could be caused by a control board problem. It could also be caused by a failed bake element, a bad oven temperature sensor probe or a wiring failure in that circuit. Check to see if the broiler works. If the broiler works, I recommend that you shut off the house circuit breakers for the range and check the bake element. If you see no visible problems with the bake element, then you can check the resistance of that component using a volt/ohm meter. It should measure between 10 and 40 ohms. If the element is bad, then it will need to be replaced. 


If that bake element is okay, then you could have a problem with the electronic oven control board or with the wiring in that circuit. You can re-install the bake element and access the electronic oven control board in the console. Pull the range out of the cabinet to access screws on each side of the console (with the house circuit breakers for the range still shut off). Remove those screws and then you should be able to fold the control panel out to access the back of the electronic oven control board. You can check the wiring. If that wiring is okay, then you can check the resistance through the bake element circuit. You should measure the same resistance through that circuit that you measured through the element itself. If the resistance is the same, then the wiring in that bake element circuit is okay. In that situation, you will probably need to replace that electronic oven control board. Here is a link that will help test the elements. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
December 15, 2014
Q:

F15 Error after Electrical Work on my Main Panel 79031073100

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Natasha12 -
Sears Technician
May 13, 2014
Q:

Clock also shows Sd in yellow 79031073100 Kenmore Elite Gas range

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when there is problems with the gas range.
 
Glad to help out.   Im  looking at your Kenmore Gas Range model number 79031073100.



That SD normally indicates that the control is in the Sales Demo mode. Try pressing and holding the COOK TIME button for 6 deliberate seconds to see if you can disable that feature. You may need to hold the START button and the COOK TIME buttons for 6 seconds.

Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".

Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.
 

Read More
Larry L -
Sears Technician
April 04, 2014

Top Parts