Model #7645 PEERLESS Faucet

  • Two Handle Washerless Valu-flo Lavatory Faucets
    3 Results
Find part by diagram >

Question and Answers

Q:

Where can I download a pdf owners manual?

A:

With your model number go to - http://www.managemylife.com/mmh/owner_manuals - Here is your Manual - http://www.managemylife.com/mmh/owner_manuals/7645/KENMORE-Residential-Washers-L0712269?brand_name_search=1102781269

Read More
Anonymous -
August 12, 2013
A:

Thanks anonymous. Can you send me a link for my matching Kenmore 80 series dryer too? The model # is: 11062802102 Thanks.

Read More
ntekos -
August 12, 2013
A:

Your welcome, Refer to link below - - You can find owners manuals @http://www.managemylife.com/mmh/owner_manuals

Read More
Anonymous -
August 12, 2013
A:

Thank you for contacting ManageMyLife.com regarding a manual for your Kenmore washer. I see an anonymous member on our site provided you with a link to the manual for your washer and dryer. I too have provided a link to the manuals below.

Washer

Dryer

I really hope this information helps you today. Thank you for using ManageMyLife.com.

Read More
Korinna S -
Sears Technician
August 13, 2013
A:

Thanks for all the info...very helpful.

Read More
ntekos -
August 13, 2013
See more answers
Q:

GE Dishwasher GSD900G-01 Why doesn't the water pump out anymore?

A:

The dishwasher is a very important appliance since it keeps the dishes nice and clean. I am adding a link below to help you with your question while you wait for your expert response.

Read More
Joseph P. -
January 25, 2012
A:

Thank you for your question and I understand your concern.

In order for your model to drain water the drain solenoid must energize and pull down the linkage connected to the drain flapper valve. You will need to remove the toe plate and access panel and watch the drain solenoid operation when you advance the timer to a drain cycle. The solenoid must pull down the metal plunger located in the center of the solenoid. The plunger connects to some linkage which connects to a flapper valve located inside the drain fitting that the drain hose is connected to. I added an image below of the drain solenoid. You should also be able to manually push the plunger down if the coil has not overheated and warped. Do not touch the any wires or terminals while the dishwasher is connected to power. If the drain solenoid is energizing and pulling the plunger down and it does not drain then I would suspect a blockage in the drain hose or where it connects under the sink.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 27, 2012
See more answers