Model #758154080 KENMORE Humidifier

  • Humidifier
    3 Results
Find part by diagram >

Question and Answers

Q:

Models 758.299825C and 758.154080 - I seem to have some of both. And a non-conforming readout regime. 758299825C Kenmore Humidifier

A:

Thanks for the inquiry and for being a valued member.

Normally, if the humidifier is flashing an "F" then the unit is not leveled. However, if you know that it is, then the problem could be the float. If it is stuck, it will cause this problem. You will need to take apart the humidifier to look at this. I would recommend that you have a technician do this. It can be very complicated. I would also suggest that you replace the filter in the humidifier as well. This will cause an issue for the plunger in the bottles.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
February 11, 2015
Q:

Why does this Kenmore Humidifier #154120 keep flashing 20?

A:

I am having the exact same problem with my 758.154080. It's the second one I've bought and I'm really frustrated. Hope we get answers!

Read More
olifer1 -
February 06, 2010
A:

A flashing 20 indicates the room humidity is less then 20%. This humidifier will read between 25% - 95%. The humidity level is lower then it will read. As the humidifier runs and brings the humidity level up, it should give the humidity reading. If you need more assistance, please resubmit your question, with additional details.

Read More
Scott D -
Sears Technician
February 08, 2010
A:

I have two Kenmore Quitet Comfort Humidifier (model 758.144115) with 11 gallon output. Both units are greater than 5 years old. Both system fans work and humidify the air. However, the external humidity reading flashes 25%. The manual says that means that the air is below 25% even after running continuously for days. I have an external humidity meter that shows the humidity in the house is near 40%. Does the humidity meter on the humidifiers need to be serviced? Is there anything I can do?

Read More
Michael -
February 12, 2011
A:

I have a Kenmore 14 gal output Humidifier Model 758154200 I got the change filter light and I changed the filters filled the tanks turned it on got the two bars that it was calibrating and it has been flashing 20% since I did this I un plugged it waited a few seconds and plugged it back in calibrated set the level and it went right to 20% this unit is not that old any thoughts

Read More
Richard P -
January 03, 2015
See more answers
Q:

The humidity sensor on my humidifier isn't working. 758.154080

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Joseph P. -
March 13, 2013
A:

Thank you for your question. I can understand your concern about the sensor. I'm attaching a picture with instructions about positioning the unit and sensor. Now, if the unit and sensor are positioned ok, it would indicate the sensor is out of calibration. Unfortunately, there is no fix for the sensor. I would recommend having a technician check this, to determine for sure, if the sensor has failed. I'm listing a site you can access, for the nearest repair center to have a tech check it. Here is a link that will provide the nearest drop-off locations: Sears Home Services. I hope this will help you.

Read More
Scott D -
Sears Technician
March 14, 2013
See more answers

Top Parts

Top Accessories