Model #75729313690 KENMORE Upright Freezer

  • Freezer Cabinet
    3 Results
  • Freezer
    3 Results
  • Door
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

replace freezer gasket

A:

I understand that you want to replace the gasket on your freezer. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful. Have a nice day.

Read More
Alina F. -
April 08, 2011
A:

The freezer gasket is held to the door with the screws that hold the inner liner to the door. The lip of the gasket goes behind the inner liner and the screws go through the hole in the liner and through the lip of the gasket.

I would put the gasket in a bathtub in hot water for 30 minutes before installing to make it more pliable and to remove any kinks in the gasket.

It is easier to remove the upper hinge and remove the door from the freezer. Lay the door on a flat padded surface and remove the screws around the outside of the inner liner.

Pull the old gasket off the inner liner and install the new gasket on the inner liner. Line the holes in the gasket up with the holes in the inner liner.

Place the gasket and inner liner on the door and install the screws. Don't tighten the screws at this time. You will have to align the door with the freezer cabinet before tightening the screws.

Snug the 8 screws in the corners of the liner and install the door on the hinges. Align the door so the new gasket is sealing and tighten the corner screws.

You will probably need to warm the gasket with a hair dryer in places to remove kinks or flat spots.

Check the door alignment with the cabinet often as you tighten the other screws. Hold the door with one hand behind the screw you are tightening to retain the alignment.

If you have questions, reply on this thread and I will be glad to help.

Read More
Jimmy K -
Sears Technician
April 09, 2011
See more answers
Q:

Can the correct panel be gotten?

A:

I'm showing the same number for the panel that you have submitted. I also found that this has been researched and it is supposed to be the correct part. Unfortunately there is no other number. This is an older freezer and the only other alternative would be to replace the outer door # 16532-102 which "might" be a complete door but it doesn't specify that. If it's not the complete door maybe a new outer door will fit the new panel but it may also be the same as what you have now.

Read More
Scott D -
Sears Technician
A:

Can't believe you want me to buy a new door???? $600 plus. The part should fit. Or contact the company that makes it and fix it. I WILL NEVER PURCHASE A KENMORE PRODUCE AGAIN NEVER, NEVER!!!!!!!

Read More
Freudenrich -
February 11, 2009
See more answers

Top Parts