Model #7549 PORTER CABLE Saw Reciprocating

  • Bayonet Saw
    3 Results
Find part by diagram >

Question and Answers


Genius II, Error code 1 and water continuously running down the drain. 625348670 Kenmore Water softener


Thank you for choosing and being a valued member.  I can certainly understand how frustrating it can be when your water softner is not working properly.

A motor fault or a bad wiring harness causes the e1 error code. A simple test is to unplug the softener for 30 seconds. Plug it back in and listen. If you here a clicking or snapping noise, the motor has failed. This is the most common. If this is the case, I recommend that the seal kit and the rotor also be replaced wit the motor. When the seals or the rotor is worn out, it will cause binding and cause the motor to fail. 

You can also visit for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
June 22, 2015