Model #7543A NORGE Residential Dryer

  • Control Panel
    3 Results
  • Control Panel Page 2
    3 Results
  • Cabinet
    3 Results
  • Cabinet Page 2
    3 Results
  • Tumbler
    3 Results
  • Tumbler Page 2
    3 Results
  • Door
    3 Results
  • Door Page 2
    3 Results
  • Motor And Drive
    3 Results
  • Motor And Drive Page 2
    3 Results
  • Motor And Drive Page 3
    3 Results
  • Heater
    3 Results
  • Heater Page 2
    3 Results
Find part by diagram >

Question and Answers

Q:

WHAT IS THE FIRST STEPS TO REPLACEMENT OF AUTOMATIC DRYER HEATER IGNITER UNIT FOR MODEL NUMBER # LNC8543A80 /LNC7543A80 SERIAL: 29H108291 BY ADMIRAL? 31001556#

A:

I think its great that you are wanting to do some repairs on your own. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question.

Read More
Joseph P. -
January 11, 2012
A:

Thank you for your question and I understand your concern. The two model number provided does not appear to be valid models. I assume it's a gas dryer and not an electric dryer.

The first step is to disconnect the power cord from the power source. The front panel will have to be taken off in order to access the glow bar igniter. There are screws along the bottom of the front panel that will need to be removed. Once the screws are removed, tilt the bottom of the front panel outwards and pull it down in order disengage the panel from the two upper clips. The igniter will be located along the end of the burner assembly. Remove the screw securing the igniter to the burner and disconnect the wire connector and remove the igniter. Reverse the procedure to install. NOTE: Be careful with the new igniter. It is very fragile. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 13, 2012
See more answers