Model #7533 PORTER CABLE Drill Driver

  • Fastener
    3 Results
Find part by diagram >

Question and Answers


Problem with a new Kenmore Elite gas range


Thank you for your question and I understand your concern.

I assume it will light with a match and the failure is the spark ignition is not operating on that the center burner. It could have a faulty switch on the gas valve for that burner or it could have loose or disconnected wire in the circuit. Whenever any burner valve is turned to "light" position, all of the electrodes for the burners should begin sparking. If the center burner spark electrode is not sparking when any of the other burner valves are turned to the "light" position, I suspect the electrode wire connection may have come disconnected at the electrode or possible disconnected from the spark module. 

Since the range is new and under the first year warranty, I suggest calling Sears and setting up a service appointment to have your range repaired.

You can have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services or by calling 1-800-4-MY-HOME. 

Read More
Joey S -
Sears Technician
November 05, 2013

What part do I need to replace on my washer?


I'm sorry to hear that you are having some difficulties with your --- . I did some research for you at and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. The expert who will assist you, can walk you through a repair like this or let you know if this may be something a technician should perform. He can also verify parts that may be required for you to order. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to I hope these links provided will assist you. If you need to order a part, the link to is also provided to your specific model below.

Read More
James -
September 27, 2011

Thank you for your question.

I am sorry you are having a problem with the washer. I recommend turning the timer to a wash cycle and starting the washer. If the hum noise is coming from down low the motor is humming. Then turn the washer to a spin cycle. If the motor just hums, the problem could be either something jammed in the pump or motor problem. If the washer does not make any noise I suspect the problem is it a lid switch failure. The lid switch has to be closed for the drain and spin cycle on your washer to work. If the lid switch is faulty, it will not attempt to drain. A quick check you can do is to jump the lid switch and see if it will drain. If the washer operates, the lid switch needs to be replaced.

To jump the lid switch you need to unplug the washer and open the console. I have provided you with the instructions for opening the console below. Once you have the console open, locate the connector for the lid switch. Place an insulated jumper between the two colored wires. Not the green it is a ground and will cause a short. After inserting the jumper make sure it will not touch anything metal, plug the washer in. Start the washer in a drain cycle. If the washer drains and spins, you need to replace the lid switch. Do not leave the jumper in while you are waiting for the part. The jumper is only of the test.

To you replace the lid switch you have to remove the cabinet of the washer. The instructions for that are also in the image below. Once the cabinet is removed you can take the screws out securing the lid switch and remove the harness from the clips along the underside of the cabinet. Then reinstall the lid switch in the reverse order. Before you reassemble the cabinet, please read the instructions for installing the cabinet provided in the image.

Please click here to watch a video on how to replace the lid switch.

I hope this is helpful. Please reply below if you need further assistance. Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
September 29, 2011
See more answers