Model #7525 PORTER CABLE Drill Driver

  • Fastener
    3 Results
Find part by diagram >

Question and Answers

Q:

What would make my Kenmore refrigerator model 7957326 to beep every few minutes?

A:



The beeping is the door open alarm. It starts if the door is left open more than 3 minutes. Make sure both doors are closing well.

If the doors are closed, check the door switches. Do this by opening a door, press the switch in with your finger and see if the light goes off and on or the fan stops and starts.

If the door switches are operating normally, the refrigerator control board will have to be replaced. The part number for the control board is 6871JB1185B. The cost is around $110.00.

Read More
expert -
Sears Technician
February 08, 2008
A:

How do you program a new control board?

Read More
Jon -
August 16, 2011
See more answers
Q:

OUR KENMORE A/C MODEL # 580.7525 1500 IS RUNNING CONTINUOUSLY ( COMPRESSOR IS ON ALL THE TIME) EVEN IN THE FAN MODE.

A:

It can be handy to have an AC unit in the home so that way you don't have a big one in the home and it can save you a lot of money. It sounds like you are having issues with the compressor like you have stated. I have researched your issue and came across a similar issue. The expert provides great detailed information on what can be the issue, i hope that it provides just enough information to get the unit working correctly.

Read More
celene -
April 11, 2011
A:

I can understand your concern. If the compressor is running even when the unit is turned off, it will indicate a problem with the main PCB assembly. It's possible the ribbon cable could be damaged and some wires shorted but the most likely problem will be with the main board. The PCB board # 6871A20167D is available at SearsPartsDirect . Thank you for using Manage My Life.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
April 13, 2011
See more answers
Q:

What is the length of the deck belt on my ZTS7500 Mower?

A:

The length specification for this belt is not available from the manufacturer. The length is specifically designed to fit the pulleys on this model of mower deck.

Read More
Carpentry Bucket -
Sears Technician
October 22, 2008
A:

Take the old belt to ANY auto parts store. They can measure it and sell you a much less expensive belt that works. I did it last year and mine is still working. Mine is a 50" deck and the belt that worked was a Gates XL 7525 11a1335 13/32" X 53-1/8" OC OR METRIC 10mm x 1346mm oc. Still working good. I wrote up how to replace it (be very safety conscious).

Read More
don -
June 20, 2010
A:

I just had mine meaused. It is 98 inches long and has a deep V. My local lawn mower dealer did not carry the part and recommed Sears.com.

Read More
Steve -
March 20, 2011
See more answers