Model #7408 PORTER CABLE Grinder Angle

  • Right Angle Grinder
    3 Results
Find part by diagram >

Question and Answers

Q:

My Kenmore Sensor Smart Gas Dryer King Size won't start. The lint filter is clean and the power is fine. Does it have a fuse?

A:

I'm sorry to hear that you are having some difficulties with your ---. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
James -
October 21, 2011
A:

Thank you for your question and I understand your concern.

Having the complete model number would be needed and additional details would also be helpful in providing model specific information. I must assume when start is pushed the estimated time displays and counts down when start is pressed.

There is no fuse inline between the electronic control board and the motor but there is a broken belt switch connected in series between the control board and motor. If the belt breaks; the belt switch will break/open the electrical circuit to the motor and prevent the motor from starting. You could have a faulty electronic control board, broken belt or faulty door switch preventing the dryer from starting.

I added a wiring diagram in the image below to reference. You can see that there are no fuse between the electronic control board and motor; only the belt switch.

So that's what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number and additional details. The model numbers are typically located above or below the drum opening. If you could supply me with that information I will be happy to assist you further.

Read More
Joey S -
Sears Technician
October 21, 2011
See more answers
Q:

I am changinging a Kenmore gas dryer, Model#110-7408-4201. back to natural gas because the previous owner converted it to propane. My question is, what is the

A:

That's great that you are wanting to change the item back on your own. I did find a similar question to yours. I placed the link down bellow and i hope that it helps good luck.

Read More
celene -
October 19, 2010
A:

There is not a conversion kit to convert your dryer back to natural gas. You will need to remove the LP gas orifice and install a Natural (NAT) gas orifice. The natural gas orifice is part #234826. Since there is not a kit or instructions for converting it back to Natural gas, I added the instructions in the image below on how to convert the dryer to LP. To convert the dryer back to Natural gas, reverse the procedure I added in the image below. NOTE: You should not have to remove the drum in order to convert your dryer back to Natural gas as mentioned in the instructions for your specific model. Just remove the lower access panel and gas valve assembly. You may not even have to remove the gas valve/burner assembly in order to remove and replace the gas orifice.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
October 21, 2010
See more answers