Model #700I SUB-ZERO Bottom-Mount Refrigerator

  • 700tc/i Door View
    3 Results
  • 700tc/i Cosmetic View
    3 Results
  • 700tc/i System View
    3 Results
Find part by diagram >

Question and Answers

Q:

kenmore 665 dishwasher not cleaning well anymore

A:

Dishwashers are the best appliance to have but when its not cleaning well it can be really frustrating. While you are waiting on an expert to answer your question, I suggest you set service with a Sears technician. I have attached the link below. Have a nice day!

Read More
Dezeray -
June 23, 2012
A:

From the description of the problem I think you nailed it when you said "there is not enough water circulating around." Over time sediment can build up on the water valve screen restricting water flow. This would cause less water to wash with. Replacing the valve might help. On most models the water should be just a 1/4 inch or so under the element.

When you opened the door did the water seem hot? When the door is open steam may roll out and the water should be noticeably hot. A bad element or thermostat might cause this problem.

A dishwasher cleaner called Dishwasher Magic available at the grocery store might help with the black goo substance. This might indicate a water heating problem.

You sound like you know your way around the motor/sump but if you reply with a complete model number I can provide you with specific tear down information. I hope this helps. Please reply with a model number and a few additional details for further assistance.

Read More
Fred M -
Sears Technician
June 26, 2012
A:

Fred, The PN is 665.13579K700. I don't think temperature is a problem, but I will double check. What do you mean by water valve screen?

Read More
Chris -
July 03, 2012
A:

Fred, Is that the separation screen (PN W10084567)? Not sure how to access it.

Read More
Chris -
July 03, 2012
A:

The screen I was referring to is located on the water valve. You access it be removing the water line. The filters that are part of the sump might also be clogged. The image below may help you access these filters. The water level should be within 1/4 inch of the element.

Read More
Fred M -
Sears Technician
July 05, 2012
See more answers
Q:

what could be wrong when the machine squeals during the spin cycle?

A:

A washer is definitely something we depend on and when it begins to malfunction it can be a huge inconvenience. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. I hope these linksa re helpful.

Read More
Jackie S -
December 26, 2011
A:

A squeal in the spin cycle is usually caused by a failure of the spin bearing. This is an expensive and difficult repair to make. It is not a good do-it-yourself project.

The tub assembly is approximately $175 dollars while labor/service call would be close to $129 dollars. The total repair would be in the $300 range. You can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this helps. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
December 27, 2011
A:

thank you; it turned out to be the bearings - total cost of repair = $600; total cost to buy a new washing machine, same model = $700 I appreciate the input.

Read More
Judith -
December 30, 2011
A:

If you're going shopping check out the new "Direct Drive" front load washers. These machines have no belt putting tension on the bearing and in theory should not have any bearing problems.

Read More
Fred M -
Sears Technician
December 30, 2011
See more answers