Model #66595788000 KENMORE Free Standing, Electric

  • Cooktop
    3 Results
  • Door
    3 Results
  • Chassis
    3 Results
  • Control Panel
    3 Results
  • Drawer
    3 Results
Find part by diagram >

Question and Answers

Q:

No power to range. 66595788000 Kenmore Electric range

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your range. Upon researching model 66595788000; The “F1 E1” error code indicates that the electronic control board may have failed. You can reset the unit by unplugging the range power cord for 30 seconds and then reapplying the power.  If the problem persists then you may need to replace the control board, I have posted a link of the control board to view the link click here.

 I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
March 25, 2015
Q:

I need to fix my stove self cleaning does not work 665.95788000

A:

Error codes are confusing. I was able to locate a similar question that may help while you wait for the expert. I also added the Sears Home Services link if a technician is needed. I hope these links help.

Read More
Barbara -
February 14, 2013
A:

Oh no. I know how frustrating it must be when this code pops up.

E1 F5 error code usually means that the door latch is not operating.

Make sure that the oven door is closed when you start the Self Clean cycle. Check the door switch to see if it is apparently operating properly. Open the oven door and the oven light should turn on. Press in the door switch plunger and the light should turn off. If the light switch is not operating properly, it could cause this type of problem.

You can also try opening the door slightly and start a cleaning cycle. It will show the door is open on the display. Press and hold the door switch to clear the message. Try manually moving the door latch and hold it in the closed position. After about 10- 20 seconds, it should start to run. Let go of just the latch  and hold the door switch down. The ltach should stay in lock position. Then try shutting off the oven. That may fix the problem. If that does not repair your problem, I recommend replacing the door latch for your oven.

I hope this helps. If you have any questions or concerns, feel free to comment back! Thank you for being a valued customer!

Read More
Samantha A -
Sears Technician
February 14, 2013
See more answers
Q:

I have a Model 66595788000 Range, while baking the error message "E2 F3" appeared, the broiler went on and would not shut off.

A:

I'm sorry that you are having some difficulties with your Kenmore Range. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. Remember that your expert can walk you through a repair like this and even assist you on ordering any required parts. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices

Read More
James -
August 03, 2011
A:

I see James provided you with some good information on the E2 F3 error code. If resetting the unit by disconnecting it from the outlet or by switching off the designated home circuit breaker for 20-30 minutes doesn't work, more than likely the control board will need to be replaced.

The image below shows the procedure for removing the electronic control board in a similar model of range. The wiring connections and components may not be exactly the same on your model, but the basic procedure for removing the control board is the same. You should be able to use this illustration as a general guide for replacing your control. NOTE : Be sure to unplug the range to completely disconnect power before accessing internal components.

If you do not feel comfortable completing this type of repair, I strongly recommend scheduling service at the link below. I also provided a link where parts can be purchased for your range. You will need the complete model number to access the parts list diagram. I hope this helps.

Sears Home Services

Sears PartsDirect

Read More
Korinna S -
Sears Technician
August 04, 2011
See more answers

Top Parts