Model #66595022100 KENMORE Free Standing, Electric

  • Cooktop
    3 Results
  • Door
    3 Results
  • Chassis
    3 Results
  • Control Panel
    3 Results
  • Drawer And Broiler
    3 Results
Find part by diagram >

Question and Answers

Q:

replacement burner 66595022100 Kenmore Range

A:

the part # is 8523697 and you can order it at sears parts website for $102.52.

Read More
Linda8247 -
Sears Technician
September 02, 2015
Q:

We have a Kenmore Range M#665.95022100, S#RL0710471 that give a code of #F2 but it doesn't give it every time we turn the oven on. We had a

A:

I can see you would like to repair the Kenmore range yourself. An expert will respond within two days to answers on your specific model. In the meantime, I hope the link provided below is helpful. Thanks for your patience.

Read More
Anna T -
February 04, 2013
A:

Thank you for your question and I understand your concern.

It should have displayed another fault code along with the F2. I added an image in a second reply to reference. It should display as shown in the fault code list.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 05, 2013
A:

Rhawk: I added a list of the fault codes below. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. It should display as shown below.

Read More
Joey S -
Sears Technician
February 05, 2013
A:

Hi Joey S, Here is the other info you needed, we foumd out it also had the code "F2 - E0". What do you recommend? Thanks!

Read More
rhawkins58 -
February 07, 2013
A:

rhawkins58: If you didn't press and hold a key pad down too long, then the membrane switch assembly will need to be replaced. The "F2/E0" indicates a shorted membrane or a buttom was pressed and held too long.

Read More
Joey S -
Sears Technician
February 08, 2013
See more answers
Q:

My stove has been stored since 5/2004 and now Kenmore smooth cooktop surface stove & oven will not heat the lights and clock on I press tech cooktop lockout?

A:

It may seem that an appliance safely stored should work correctly once connected and turned on. If this was my range I would want it inspected before use. If you decide you would like to schedule a technician to check it out and make any necessary repairs, an option is to visit Sears Home Services at the link below to use the scheduler. Peace of mind is worth the cost. Just an option while you wait for the expert.

Read More
Barbara H. -
March 26, 2011
A:

Thank you for your question.

I can understand wanting your range to work after being stored for a few years.

If the range was working fine before the storage time and since this may be a new location do we know for sure that the electrical requirements have been met.

The range requires 240 volts AC to operate correctly.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Is it possible that some wiring damage could have occurred during storage? It that is possible you may have to remove the back panel and do an expectation of the wiring if you have not already done so.

It really sounds like you do not have the correct voltage going to the range.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
March 28, 2011
See more answers

Top Parts