Model #66575775891 KENMORE Free Standing, Gas

  • Cooktop
    3 Results
  • Control Panel
    3 Results
  • Manifold
    3 Results
  • Chassis
    3 Results
  • Door
    3 Results
  • Drawer And Broiler
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore plus oven not working

A:

Half of the cooking features working are something, but not with dinner to prepare. I did locate two similar questions that may provide information on this problem while you wait for the expert response. I attached the links below. I hope this helps get you back to cooking on all elements.

Read More
Barbara H. -
April 22, 2012
A:

Thank you for your question and I understand your concern.

In order for the bake burner to operate; the electronic oven control must close the bake relay in order to complete the path of voltage to the bake igniter. The bake igniter is mounted at the back of the bake burner. The bake igniter must glow red hot and it must pull enough current/amperage in order to cause the oven gas valve to open. The oven floor can be removed in order to access the bake igniter. If the igniter is glowing, the igniter is likely too weak to cause the gas valve to open and the igniter will need to be replaced.

If the igniter is not glowing; it could have a broken igniter, faulty bake relay on the oven control or a faulty oven gas valve. If the igniter is not glowing; the igniter can be disconnected and tested for continuity with an Ohm meter. It measures continuity then I would suspect a faulty electronic oven control board.

Be sure to disconnect the range from the power supply before accessing and removing the bake igniter for testing.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
April 24, 2012
See more answers
Q:

What does "F2-E0" fault code mean on my Kenmore gas range?

A:

The "F2-E0" fault code indicates a shorted or stuck key button. The electronic oven control will likely need to be replaced if none of the keys appear to be stuck.

The electronic oven control is offered in 3 colors; Almond, Black or White.

  • Almond control- part #8053741R
  • Black control- part #8053739R
  • White control- part #8053740R

The control board can be removed and replaced by disconnecting the power cord from the power source and removing the panel behind the control panel. Make a note of where the wires attach on the control board before disconnecting the wires. Remove the screws securing the control board to remove.

Read More
Joey S -
Sears Technician
December 22, 2009
Q:

Why won't the broiler come on or light?

A:

The broil burner igniter may have broken. When you push the broil key pad and then the Start/Enter pad if you hear a faint click from the broil relay that would likely indicate that the control is OK and most likely the broil igniter is bad. The broil igniter and the bake igniter are exactly the same igniters. You could remove the broil igniter and swap it with the bake igniter to see if the broiler will work.

I recommend calling a service technician to diagnose and repair your broiler.

Read More
Joey S -
Sears Technician

Top Parts