Model #66575163301 KENMORE Free Standing, Gas

  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Manifold Parts
    3 Results
  • Chassis Parts
    3 Results
  • Warming Drawer & Broiler Parts, Miscellaneous Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

My kenmore ultra bake oven stopped working and i'm getting an error code E1-F2. Model number 665.75163301

A:

Good afternoon.... I can understand your concern and you've done a good job at trying to get to the bottom of this problem. I did locate a link that will discuss this situation in greater detail. It even mentions the ribbon you've discussed. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will enable you to address and complete the task before you and have a nice day.

Read More
Henry -
December 18, 2012
A:

Replacing the membrane key pad is the next step in troubleshooting that problem. That membrane keypad is circled in red on the parts drawing shown below. You can order that part from this page: Kenmore Range Model 665.75163301 Control Panel Parts . Be sure that you unplug the range before accessing internal components and replacing that part.

If you replace that membrane keypad and the code still appears on the control, then you will need to replace the electronic control board as well.

If you need more help, reply with additional details.

If you get to the point where you need to have a service technician examine and repair the range, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 19, 2012
A:

Thanks for your prompt responses. I will certainly be following your directions and hopefully will be finally able to resolve this. Thanks again.

Read More
Mike -
February 15, 2013
See more answers
Q:

My Kenmore Ultrabake, model #66575163301 has switched from Fahrenheit to Celsius after fixing a door lock problem. How do I switch it back?

A:

Having to work with the features and settings on an appliance can be tricky. I have taken the time to research your model on the Manage My Life website and have located thee owners manual to your model. While you are waiting for a detailed reply from an expert I have attached the link below.

Read More
Priscilla V -
May 11, 2011
A:

Thank you for your question and I understand your concern.

To change it from Celsius back to Fahrenheit: Press and hold BROIL for 5 seconds. A short tone will sound, and the temperatures displayed will switch to "F." Repeat to change it back to Celsius.

See image below.

Read More
Joey S -
Sears Technician
May 12, 2011
A:

I tried holding the broil button for 5 seconds to change the display from celsius to fahrenheit, but nothing happens

Read More
Anonymous -
October 05, 2012
A:

Anonymous: Without knowing the model number of your range I can't be certain if the directions above in the previous answer will apply to your model. Reply with the model number for model specific information.

Read More
Joey S -
Sears Technician
October 06, 2012
See more answers
Q:

Why is there a spider web between the oven door glass panels on my Kenmore range?

A:

The space between the oven door glass panels is not sealed. Air flow is needed in between the glass to dissipate heat properly. The spider must have crawled in through one of the openings in the oven door.

You can try to remove it using some of these tips:

  • Try running a Self Clean cycle on the oven. Depending on the size of the web, this may burn off the web or push it out with the air circulation during this cleaning cycle.
  • You can try blowing canned air (usually used for cleaning computers) through the vents of the oven door to remove the web.
If these tips don't help, then it is likely that the door will have to be pulled off and disassembled to remove the web. The parts diagram of your door is illustrated in the image below. It has numerous internal parts. I recommend calling a service technician to complete this task if necessary.

Read More
Lyle W -
Sears Technician
August 20, 2008

Top Parts