Model #66517599202 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Miscellaneous Parts Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore elite dish washer

A:

It ca n be a real head-ache when your dishwasher fails on you. I did some research on the problem and provided a link to a similar question and answer on our site. I hope this will give you a better idea on the next step to take until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
September 21, 2012
A:

I wouldn't assume it is the motor right away. Usually I find that the source of the smell and loss of power is due to a malfunction in the control board area behind the console. Open the circuit breaker for the dishwasher and have a look and a sniff behind the conole (where the keypad is).

Read More
Chat in RI -
September 21, 2012
A:

I can understand the concerns that are raised when any appliance stops mid cycle and has a burning smell. There is never a good time for these problems.

First, I would check the house circuit breaker and power supply connection to the dishwasher.

Here is a good video to check the voltage to the dishwasher; Video .

If the circuit breaker and line checks good, then I would check the power connections in the control panel.

NOTE: Disconnect the dishwasher from the power supply before removing the console and checking the connections and wires for any signs of overheating.

Loose connections will cause high resistance as the current is flowing through the circuit which can cause wires and connections to overheat. If you have an ohm meter and feel comfortable performing these tests, you can use the images below to check resistance of all connections in power up circuit to control. Also check the connections between keypad and control.

If these connections check ok, then I would focus on a possible blown thermal fuse as the link Julio provided recommends.

The images below will help check the power circuits in question. If you do not feel comfortable doing these checks, you can schedule a Sears technician here; Sears Home Services .

If more information or assistance is needed, please reply back. Thank you for using Manage My Life.

Read More
Barbara H. -
Sears Technician
September 22, 2012
See more answers

Top Parts