Model #66517262401 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Mounting Kenmore Dishwasher mod 665.17262401 in to Granite counter

A:

You should not have to drill any holes in the cabinet.  There is a way to side mount the dishwasher.  The instructions are shown below.  You will remove and move the 2 top installation brackets.  O hope this information is helpful to you.  Thank you for using Manage My Life. 

Read More
Fred M -
Sears Technician
August 24, 2013
Q:

kenmore elite dishwasher not running

A:

Flashing lights in sequence do reflect error codes. While you wait for the expert, you can check the link below for some information. I would suggest adding the complete model number to help the expert provide the best information possible.

Read More
Barbara -
July 26, 2012
A:

model number 66517262401

Read More
christine -
July 26, 2012
A:

Thank you for your question and I understand your concern.

Based on your description I must assume the green "CLEAN" LED is flashing 7 times pauses and continues to repeat.

The flashing "Clean" light indicates the control board did not detect an increase in the water temperature in the main wash. The control can be reset by pushing HEATED DRY - NORMAL - HEATED DRY - NORMAL and then allow the dishwasher to run for minute and then press Cancel/Drain and then wait for it to complete the drain cycle.

I added an image below with the possible causes and the solution.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 27, 2012
See more answers
Q:

I need the wiring diagram for a 665-17262401 kenmore dishwaser can you help me with that?

A:

I understand your concern toward needing a wiring diagram and I hope to be of some help. While you are waiting for an expert answer, I know that only the expert can provide you with a wiring diagram. I did manage to find a link in where you can enter your model number and your owners manual will pop up: http://www.managemylife.com/mmh/owner_manuals. I hope my link is useful.

Read More
Joseph P. -
October 28, 2010
A:

Thank you I will try that out right now Thanks Ron

Read More
metal atr -
October 28, 2010
A:

Thank you for your question.

I have provided you with the wiring diagram below. Please make sure to turn the power off to the dishwasher before removing the service panels.

If you need further assistance, please reply below with more details.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 29, 2010
A:

Mr. Mark, Came across the page looking for a wiring diagram as well. My issue ( same model as above) the unit cycles through all functions. Except pumping the water out. I have removed it from the space. To my shop, cleaned all connections, checked for blockage of any sort. Watched the Master switch rotate through an entire cycle. Single motor, works fine when it is on the clean cycle, spins up nice for the time allotted. Alas it never kicks in to empty the washer. I am guessing this is possibly a problem in the master switch?

Read More
Ritch -
July 28, 2011
See more answers

Top Parts