Model #6651678583 KENMORE Dishwasher

  • Console Panel
    3 Results
  • Heater, Pump And Lower Sprayarm
    3 Results
  • Pump And Motor
    3 Results
  • Tub
    3 Results
  • Door And Toe Panel
    3 Results
  • Dishrack
    3 Results
  • Wiring Harness
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Undercounter Dishwasher Kenmore

A:

I know how important it is to have a good working Dishwasher in the home can be. I have taken the time to research on the Manage My Life website and have located information similar to your issue. While you are waiting for a detailed reply from an expert I have attached the links below. Hope this helps!

Read More
Priscilla V -
January 30, 2012
A:

Thank you for your question and I understand your concern.

Be sure and check to make sure the dishwasher is filling with enough water. The water level should be just touching the safety float in the front corner after completing the fill cycle. Also, the incoming water temperature must be a minimum of 120 degrees. Another critical component is the heating element. The heating element must be in working order to heat the water up as its washing. To check the heater operation, open the door and advance the timer to the dry cycle and then shut the door. Give it a minute or so to heat up and then drip a drop of water on the element to see or listen for a sizzling sound. If the heater is not working, this could be caused by a faulty timer, heating element or faulty operating thermostat or high limit thermostat. The thermostats are located up against the bottom of the tub. Both thermostat should be closed/measure continuity in order to complete the path of voltage to the element and timer motor. The timer will pause until the water is heated up to a certain degree which is controlled by the operating thermostat. The thermostats can be disconnected and tested for continuity with an Ohm meter. NOTE: Disconnect the dishwasher from the power supply before testing the 2 thermostats for continuity.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 01, 2012
See more answers

Top Parts