Model #66516582200 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Miscellaneous Parts Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I was given an Kemore Elite Diswasher model # 16582200 or 66516582200. The digital display lights that used to come on when sensing don't cycle or light up.

A:

I know how important it is to have a good working dishwasher in the home so that you can keep your dishes nice and clean. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about what may be causing your problem. I hope my link is useful.

Read More
Joseph P. -
February 14, 2011
A:

What concerns me most about this problem is the "control lock" will not turn off.

Just to be clear the Air Dry button controls this feature. Press and hold the Air Dry keypad for 4-5 seconds to see if the control lock will turn off.

If not then the next step would be to access the control and disconnect the ribbon to the interface/console. Remove the ribbon and try to plug it back in and see if you get lucky.

The first image will help with this.

The 2nd image is a diagnostic test. This may work and will run all functions if the console will clear the control lock.

The console/interface can be obtained from the following site: Sears PartsDirect .

I hope this helps. You can reply with any additional detail for further assistance.

Read More
Fred M -
Sears Technician
February 15, 2011
A:

Think I have everything in working order now, thanks for your help. Turns out the plug underneath the control panel was not snug so the digital display was not working. Figured out the "lock" also. Now I am with out mounting brackets, will try to locate some or will have to buy them online. Do they just slip into the slots on the top of the dishwasher frame?

Read More
Greg -
February 15, 2011
A:

You can get the 8269145 brackets at SearsPartsDirect. They do just clip onto the frame of the dishwer.

Read More
Fred M -
Sears Technician
February 16, 2011
See more answers
Q:

Wht does my Kenmore dishwash model 665.16582200 not pump out all the water in rinse cycle?

A:

Core Issue:

Why does my Kenmore dishwash model 665.16582200 not pump out all the water in rinse cycle?

Answer:

I recommend checking the dishwasher drain line under the sink first. Loosen the hose clamp & pull the drain hose off, place it in a bucket & turn on the dishwasher to a drain cycle. If the water does not drain out I suspect a faulty drain pump. If the drain pump motor is on & running & no water is draining, you will need to replace the drain pump motor. If the drain motor is not receiving voltage & the harness checks good, I recommend replacing the control board. There is a float in the bottom of the tub that detects your water level.

Read More
Jerome G. - Personal Solutions Manager -
Sears Technician
December 02, 2009

Top Parts