Model #66516282400 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

my kenmore elite dish washer, model 65516282400, will not start. The clean light stays on after pressing the cancel switch. The clean light blinks 7 times/

A:

Dishwashers are such a handy appliance and always help with the life style that many people have, such as constantly being on the go. I furthered your search and noticed that someone else had asked a similar question with a posted response from an expert. I have attached the link below because I am sure they will be able to help you. Good luck!

Read More
Alina F. -
October 16, 2010
A:

The clean light blinking 7 times indicates a water heating circuit failure somewhere. You will need to reset the control & see if the unit will start operating again properly. If not several component checks will need to be made with a meter. I am sending the list of possibilities in the image provided in the attachment below. I am also sending you a video of the testing & diagnosing covering this symptom. If you have a meter & decide to perform the checks & testing please reply back with us on this.

Please click on the link below.

http://vids.myspace.com/index.cfm?fuseaction=vids.individual&videoid=30482808

Read More
biker dave -
Sears Technician
October 17, 2010
A:

hOW DOES A PERSON LOGIN?

Read More
Larry -
October 17, 2010
A:

at the top of the home page you will see log-in or sign-up. you need to sign-up before you can log-in.

Read More
biker dave -
Sears Technician
October 17, 2010
See more answers
Q:

What are precise steps to install part 8564546 in dishwasher model 665.16282400?

A:

First, shut off the breaker for the dishwasher to disconnect electrical power. This is very important.

The procedure for accessing and removing the control board (part 8564546) is shown in the image below. You can reverse the procedure to reassemble the dishwasher.

You should not need any special tools. Some dishwashers will have Torx screws in the inner door panel that must be removed. You may need a Torx screwdriver but this is a common tool that you should be able to find at your local Sears store or hardware store.

I don't have these instructions in Spanish. The images will likely help you complete the repair.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
November 10, 2009
Q:

Why is the clean light flashing on my Kenmore dishwasher?

A:

Please see the image provided for the information that you requested. This type of symptom will not always require parts to be replaced.

Read More
biker dave -
Sears Technician

Top Parts