Model #66516272401 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Machine wont run

A:

Thank you for your question and I understand your concern.

In order to provide any model specific information, I will need to know the model number of the product. Based on the "green light" flashing, I assume this could be a dishwasher. If it is a Kenmore dishwasher and the "clean" light is flashing, the control may not be sensing any water heat during the main wash. If the heater inside the dishwasher is not raising the water temperature in the dishwasher 2-4 degrees, the "clean" light will flash and the dishwasher will not operate.

I added a link that may pertain to you model with instructions on how to clear the flashing "clean" light. 

So that’s what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number. The model numbers are typically located on the inner edge of the tub after opening the door. If you could supply me with that information I will be happy to assist you further. 

Read More
Joey S -
Sears Technician
December 03, 2013
A:

The model # for this dishwasher is 665.16272401.

Read More
Greggory -
December 03, 2013
A:

Greggory: Thank you for adding the model number. The information and link I provided earlier will pertain to your model dishwasher. To clear the flashing "clean" light, Press the following keys in order and in less than 6 seconds. Heated Dry - Normal - Heated - Normal and then let the dishwasher run for a couple of minutes and then you can press cancel and let the dishwasher drain and time out. Your dishwasher will operate again and if there is failure in the heater circuit, it will flash the clean light again 2-3 cycles later.

Read More
Joey S -
Sears Technician
December 03, 2013
See more answers

Top Parts