Model #66516032403 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

No Pressure 020228 Briggs&stratton Pressure washer

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your dishwasher. Upon researching model 66516032403:  Check to make sure the inlet screen is not plugged up. Also, remove the screen and look down in the inlet tube and make sure there isn't a lot of calcium deposits build up in there. If those things look good then there may be a problem with the unloader. You can remove the unloader and make sure it's clean. If it looks clean then the unloader itself may be bad. Before you condemn the unloader and get a new one, make sure to take the check valves out and make sure they're clean and not damaged.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
July 08, 2015
A:

Thank you for the help, but I have problems with my pressure washer model # 020228

Read More
COLLIN -
July 08, 2015
See more answers
Q:

panel lights flashing, washer won't start 66516032403 Kenmore Dishwasher

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your dishwasher. Upon researching model 66516032403:  you can reset the unit by unplugging the unit power cord for 5 minutes and then reapplying the power.  I have posted an image below of the diagnostic cycle that a technician would normally run. Note: the diagnostic cycle and the instructions below are mean to be used a certified technicians.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
July 08, 2015
A:

thanks, tried the unplug solution, and now the normal light is blinking. cannot read the image you sent along, it is too small, even if I magnify it. perhaps the problem is that I have a mac. can you resend it as a pdf file? ann

Read More
ann -
July 08, 2015
See more answers
Q:

electrical connection 66516032403 Kenmore Dishwasher

A:

Thank you for choosing Sears PartsDirect.com. Glad to help out. I’m looking at your model number 66516032403 and the connection used is located to the lower right front of the dishwasher. You will need to remove the kick panel so that you can see where the box it is located in. Here is a link for a video that will show how to install a dishwasher including where the connection is made. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
November 29, 2014

Top Parts