Model #66516029402 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

no power to dishwasher 66516029402 Kenmore Dishwasher

Q:

dishwasher

A:

Thank you for contacting ManageMyLife.com regarding the clean light flashing on your Kenmore dishwasher. I'm happy to help you today.

 

If the dishwasher won't run at all and the clean light is flashing 7 times, it is because the control thinks the heater is not working. You can clear the error by running a diagnostic test but if the heater isn't working then the lights will flash again until the problem is fixed. The image below will show you how to enter and run a diagnostic cycle (Heated Dry, Normal, Heated Dry, Normal).

This should clear the error and allow you to use the dishwasher. Try to notice if there is any steam at the end of the cycle or if the dishes are hot to touch.

 

If there is no steam and the dishes are not hot then it is likely the heater is not working. The problem can be the element, hi limit thermostat or control. If the flashing continues or happens to come back, I would strongly recommend scheduling service. Sears Home Services.

 

I really hope this information helps you today. Thank you for using ManageMyLife.com.

Read More
Korinna S -
Sears Technician
November 23, 2013
Q:

dishwasher will not start

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina F. -
October 27, 2011
A:

The start light blinking 3 times may indicate a problem with the door switches.

The image below shows how to enter a diagnostic cycle which may help.

Try the test and check the door switches and let me know what happens. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
October 29, 2011
See more answers

Top Parts