Model #66515795791 KENMORE Dishwasher

  • Frame And Console
    3 Results
  • Inner Door
    3 Results
  • Tub Assembly
    3 Results
  • Pump And Motor
    3 Results
  • Upper Dishrack And Water Feed
    3 Results
  • Lower Dishrack
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >


Error Codes

Error Code:



Question and Answers


Green Flashing clean button 66515795791 Kenmore Undercounter dishwasher


Thanks for using, and for being a valued member. 

The clean light will flash for several different reasons, including a failed control board, or a failed pump, etc. The most common issue is with the heater. A heater fault detection program has been added to the electronic control to monitor the operation of the heater. If a temperature rise in the water is not detected during the first 8 minutes of the beginning of the main wash, the dishwasher will shut down.

A fault will be indicated if:

A 2°F increase in the water temperature is not obtained (inlet water temp greater than 90°F) or

A 4°F increase in the water temperature is not obtained (inlet water temp less than 90°F).

If the correct temperature rise is not detected, the dishwasher will drain and blink the clean light 7 times.

Possible causes that could keep the water from properly heating:

Open in Heating Element circuit (heater, thermostat, or wiring)

Neutral side Door Switch not closing (check switch and door latch assembly)

Note: Neutral side door switch only used for heater circuit

Water not coming in or lack of water (check inlet valve circuit and water pressure)

Lack of water circulation (pump motor or restriction in circulation channels)

Siphoning of water during fill (check drain hose for proper installation)

If you would feel more confident have a Sears Home Service technician help assist with the diagnosis/repair, you can call 1-800-349-5071, or click here to be directed to the page to set up service.

I hope this helps, and thanks for using We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
September 20, 2014

How do I reinstall 2 purple rubber rings I found on the bottom rack of my dishwasher?


Thank you for sending a picture of the rings. These rings are not parts from the dishwasher. They may have come out of an item or dish that you washed inside the dishwasher but they are not off of the dishwasher itself. You can continue to use the dishwasher. Look for the source of these rings in any of the items or dishes that you have washed in the dishwasher.

Read More
Lyle W -
Sears Technician
October 23, 2009

How do I reinstall 2 purple rubber rings I found on the bottom rack of my Kenmore dishwasher?


From the description you give it sounds like the gasket for the sump as shown in the iamge below. This is not mounted to the rack and would only be loose if the motor was recently changed.

If the picture below doesn't look like the object you have then you may need to submit a question with a picture of the object you have.

The rack on this dishwasher has no 8 inch diameter purple ring mounted to it. Racks may have a knife holder or a clip to hold small items but they're not 8 inches in diameter.

Please submit another question with additional details and/or a picture for futehr assistance with this problem.

Read More
Fred M -
Sears Technician
October 19, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show