Model #66515725690 KENMORE Dishwasher

  • Frame And Console
    3 Results
  • Inner Door
    3 Results
  • Tub Assembly
    3 Results
  • Pump And Motor
    3 Results
  • Dishrack
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

connections 66515725690 Kenmore Dishwasher

Q:

Removing a Lower Arm

A:

I found some information for you that I am hoping will help you. I am adding the link below to help you with your question while you wait for your expert response.It may take 24-48 hours. I do hope everything works out with the dishwasher.

Read More
Marc -
October 26, 2012
A:

Thanks for contacting ManageMyLife.com. I understand how frustrating it is having trouble with removing the lower spray arm from the dishwasher. We are here to help. The image below gives the full instruction on the lower spray arm removal. I hope this helps.

To order dishwasher parts, please visit SearsPartsDirect.com with the model number.

Please feel free to let me know if you need further assistance. We are always here to help.

Thank you for using ManageMyLife.com.

Read More
John H -
Sears Technician
October 27, 2012
A:

John Thank you, That was easy once I saw the picture... took about 3 sec to change out the arm bearing..

Read More
Bill -
October 27, 2012
See more answers
Q:

My undercounter dishwasher is leaking. Where should I start to troubleshoot?

A:

I understand that your dishwasher is leaking. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below if you are interested in viewing. I hope the link that I provided is helpful.

Read More
Alina F. -
April 15, 2011
A:

The leak might be the gasket but there are a couple of other reasons it might leak.

The sprayarm may be spraying water out under the door. Look for any cracks along the seam.

The top of the pump housing is held by 8 or so screws. If one is loose the a wave action might push water under the door. Make sure all of these screws are tight.

I hope this information is helpful to you but reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
April 16, 2011
A:

Fred...thank you for you expert response. I checked the screws on the pump housing and all seemed tight. I removed the spray arm and cannot detect any splits in the metal. I have ordered a new door gasket and will install it when it arrives.

Read More
raymond -
April 20, 2011
A:

Good luck and let us know if we can help.

Read More
Fred M -
Sears Technician
April 20, 2011
See more answers

Top Parts