Model #66515669992 KENMORE Dishwasher

  • Frame And Console
    3 Results
  • Inner Door
    3 Results
  • Tub Assembly
    3 Results
  • Pump And Motor
    3 Results
  • Dishrack
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Cycles don't advance automatically 66515669992 Kenmore Dishwasher

A:

 

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when your dishwasher does not go through the complete cycles automatically. I did look into the model number you have provided and I have found that if your unit is not cycling automatically and you have to manually turn the timer for the next cycle then your timer itself is going bad. The timer should allow all the cycles to cycle properly without having to do it manually. If you would like to order the timer you can always visit searspartsdirect.com when you are ready.

 

Thank you for your question. Have a great day.

Read More
Natasha12 -
Sears Technician
November 27, 2013
Q:

How are the wires on kenmore dishwasher inlet valve connected

A:

I see you are trying to connect your wires on your Kenmore dishwasher which can be very challenging to do because it is difficult to understand which wire goes where. A suggestion that I have while you wait on your response from an expert is going on to the Sears Parts Direct website and searching to see if you have your diagram to your part. I have attached the link below for you to view. Hope this helps!

Read More
Alina F. -
September 10, 2010
A:

It does not matter which way the wire connector is connected to the water valve.

Read More
Joey S -
Sears Technician
September 10, 2010
A:

I have a kenmore ultra wash 665.13732k601 dishwasher and it will not let in the water or dump the water when I manually fill it. I have tried searching all over your website and the internet for a wiring diagram wiht no luck. I have replaced the inlet valve since the last one cracked and leaked but it does not work. I have 4 volts to the inlet valve and 40 volts to the pump dump selenoid. Would you forward me a wiring diagram, and if you can tell me if the voltage is correct to each of these parts then both parts are faulty or if not then maybe it is the control board. What are your thoughts or direction for trouble shooting this?

Read More
Phil -
May 06, 2013
A:

Phil; The water inlet valve and the drain pump operate on 110-120 volts AC. I added an image below of the wiring diagram. If there is no loose or bad wire connections between the control board, float switch and water valve, it likely has a faulty electronic control board. If there is no loose or bad wire connection between the drain pump and control board, this too would point to faulty control board if the pump is not getting the 110-120 VAC voltage supply. There should be a tech sheet inside the control panel or it could be up under the front of the dishwasher tub or behind the toe panel. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
May 06, 2013
See more answers
Q:

After our 8 year old Kenmore dishwasher completes washing dishes, some water remains in bottom.

A:

Please review the previously answered questions on this topic. We have answered this question several times on this site.

Read More
biker dave -
Sears Technician
A:

That was pretty NOT HELPFUL!

Read More
Anonymous -
May 21, 2010
See more answers

Top Parts