Model #66513843K602 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I had the dishwasher doing a cycle when I came to deal with it I see it has no panel lights on and the soap tablet is on the bottom in a pile of water.

A:

With the dishwasher not working can be rather frustrating. I have done some research on the Manage My Life website and have located a link similar to your issue. While you are waiting for a detailed reply from an expert I have provided the link below. Hope this helps!

Read More
Priscilla V -
June 12, 2012
A:

Thank you for your question and I understand your concern.

The first step is to confirm and verify the voltage supply and the electrical connections inside the electrical junction box under the front of the dishwasher. Flip the circuit breaker off dedicated for the dishwasher before removing electrical junction box cover. You will need to remove the screws securing the lower toe panel and then remove the panel. Remove the screw from the cover and take the cover off.

You will find a pair of black and white wires connected with a wire nut. Remove the wire nuts and inspect the wire connections. Separate the black and white wires so they do not touch each other or any metal on the frame. Flip the circuit breaker back on and then measure the voltage. With the black and white wire disconnected, the voltage should measure 110-120 volts when measuring across the black and white wires on the power supply side. NOTE: I do not recommend measuring the voltage supply unless you have experience and feel safe and confident in doing so; otherwise I suggest calling a service technician to diagnose and repair your dishwasher.

If the voltage supply measures 110-120 volts, and the dishwasher will not power up after reconnecting the wires; I would then access and test the thermal fuse for continuity located inside the control panel (see image below). You will also need an Ohm meter to check the thermal fuse for continuity. If the thermal fuse is open/faulty; the dishwasher will not power up. Flip the circuit breaker off before removing the control panel and disconnecting the thermal disc/fuse. If you find the thermal disc/fuse faulty, the thermal fuse #661662 for Kenmore dishwasher model 665.13843K602 can be ordered from Sears Parts Direct.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
June 14, 2012
See more answers

Top Parts