Model #66513842K600 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Lower Washarm Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dishwasher model 66513842k600. I found inside my dishwasher a blue rubber belt about the size of a band that would go around a head

A:

I hate doing dishes by hand! I'm sorry to hear that you are having some difficulties with your Kenmore Dishwasher. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices. I hope these links provided assist you.

Read More
James -
November 22, 2011
A:

The part that you are describing sound like the seal for the lower spray arm. However, there are multiple seal inside the wash tub. You can remove the lower spray arm and the feed, and check to see if the seal is there. If not replace it. If it is, you will need to check for leaks and loose parts to determine where this would go. If you need further assistance, please reply to this thread.

Read More
AnneJ -
Sears Technician
November 24, 2011
A:

Thank you for your reply. We did figure it out. It turned out to have nothing to do with the dishwasher. We have a serilite plastic-ware set of bowls and lids. The square lids have blue bands around them for sealing to the bowl. I noticed it when another blue band showed up in the bottom of my dishwasher. And then noticed the blue bands on my other lids. And sure enough two of my lids were missing there blue band. Mystery sloved.

Read More
Kim -
December 15, 2011
See more answers
Q:

cancelling fault code

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina F. -
November 05, 2011
A:

Hi,

Thank you for submitting a question to Manage My Life.

You did not mention whether or not the heater is working. You can run the diagnostic cycle (see image below) and this will reset the defaults, but if the heat circuit is not functional the error will continue. If the fault does not go away, or the heater does not function the remaining checks will require the use of an ohm/volt meter and you will have to perform ohm checks and/or live voltage checks. If you have a meter and are confident in your ability to safely perform these checks, reply to this post and I will be happy to assist you further. I have included a wiring diagram and heat circuit strip in the image below. I have marked the heat circuit components for you with red arrows.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram and for parts purchases; Sears Parts Direct .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Landell

Read More
Landell -
Sears Technician
November 06, 2011
See more answers
Q:

Why do only some buttons on my dishwasher's front panel respond?

A:

The failure could be just a loose ribbon connector on the control board from the touch panel. It could also have a bad touch panel too. The key pad can be tested with an Ohm meter. I added the instructions in the image below. NOTE: Disconnect power to the dishwasher before removing the console and checking the key pad.

Read More
Joey S -
Sears Technician
November 03, 2009

Top Parts