Model #66513829K601 KENMORE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dishwasher not cleaning 66513829K601 Kenmore Dishwasher

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when there is problems with the dishwasher.
 
Glad to help out.   Im  looking at your Kenmore Dishwasher model number 66513829K601.

Could be hard water deposit build up in the lines.   Would get some dishwasher magic to put in there to clean the lines.   I would take out the spray arms and soak them into some warm water with vinegar.   If that works great.   Most likely though be best to get some new spray arm and dishwasher magic.   Best to use that dishwasher magic one time every three or four months.
 

Spray arm for model 66513829K601

sray arm seal for model 66513829K601

Dishwasher Magic for model 66513829K601

Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".
 
Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.
 


Read More
Larry L -
Sears Technician
June 04, 2014
Q:

not running thru cycles

A:

I know how important it is to have a good working dishwasher in the home so that you can keep your dishes nice and clean. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your dishwasher troubles while you wait for your expert response.

Read More
Joseph P. -
January 02, 2013
A:

The Heated Dry - Normal - Heated Dry - Normal keydance placed the control in a diagnostic test mode and it runs a quick test cycle. I recommend that you try to run that test cycle again. The image below shows the technical information for that test cycle. This may help you determine the cause of your problem. If that circulation pump is not running, then you may have a problem with that component.

If you determine the cause of your problem and need parts, you can order them from this page: Kenmore Dishwasher Model 665.13829K601 Parts . Be sure that you shut off the house circuit breaker for the dishwasher before accessing internal components and replacing parts.

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 04, 2013
See more answers

Top Parts