Model #66513614101 KENMORE Compactors

  • Motor And Drive Parts
    3 Results
  • Frame Parts
    3 Results
  • Powerscrew And Ram Parts
    3 Results
  • Container Parts
    3 Results
  • Cabinet And Control Parts
    3 Results
  • Accessory Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Trash Compactor is making loud noise

A:

The Ram Stop part I've ordered from Sears is 9870037 (I'm getting 2 as both have been destroyed).

Read More
Stel -
December 10, 2012
A:

I am sorry that you are having some difficulties with your trash compactor and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I am also adding a second link in where you can set service to have your compactor repaired by a certified technician. I hope this helps with your repairs while you wait for your expert response.

Read More
Joseph P. -
December 10, 2012
A:

This is an ambitious do-it-yourself project. The top panel will need to be removed then the ram pulled out. The unit will need to be laid on it's side to access the nuts holding the power screws. Remove the nuts to remove the power screws. I hope this helps. Good luck.

Read More
Fred M -
Sears Technician
December 11, 2012
A:

OK so I got the parts to day and one of the power screws was extremely easy to remove and replace the ram stop on. The other one will not unscrew from the ram. I'm unscrewing it and when the top of the thread gets to the plastic not on the ram it stops. Any ideas? Thanks in advance. Stel

Read More
Stel -
December 12, 2012
A:

Also a suggestion on the type of grease to re-grease the cogs with on the bottom of the power screws.

Read More
Stel -
December 12, 2012
A:

Try heat or oil soak on the nut. The grease for the power screws is part number 675351 and can be obtained from the following link: SearsPartsDirect .

Read More
Fred M -
Sears Technician
December 15, 2012
See more answers
Q:

Why is my trash compactor not working correctly?

A:

What you are describing sounds like the motor has failed. In order to determine the exact cause of the problem the motor will need to be checked with a meter. Here is a copy of the service manual information that will help you make some diagnostic checks.

Read More
biker dave -
Sears Technician
November 18, 2008

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show