Model #66513442K901 KENMORE Dishwasher

  • Frame And Console Parts
    3 Results
  • Inner Door Parts
    3 Results
  • Tub Assembly Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Dishrack And Water Feed Parts
    3 Results
  • Lower Dishrack Parts
    3 Results
  • Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

i have a Kenmore Model 66513442K901 under counter Dishwasher, It will not start, it has power and only some of the buttons light up when pushed, any ideas

A:

When the Kenmore dishwasher will not start, it may be as simply as checking a fuse, as you will see in the link provided below. Hope this information helps while waiting for an expert on your specific model. If you decide on service, that link is also available.

Read More
Anna T -
January 16, 2013
A:

Thank you for your question and I understand your concern.

Disconnect the power supply from the dishwasher by flipping the house breaker off dedicated for the dishwasher circuit and leave it off for 10 seconds. Flip the circuit breaker back on and then see if the dishwasher will start. If it does start, the door switch or door latch is faulty. The control must see the door open after a completed cycle or it will not restart.

If it will not add water and the pump/motor assembly will not operate when "Cancel/Drain" is pushed, it could have a faulty control board, and/or it could have faulty control panel.

The control panel button switches can be tested with an Ohm meter. If all the buttons test Okay, I suspect a faulty control board.

I will add an image in another response with troubleshooting information. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 18, 2013
A:

Kent: I added an image below and it will have the information on how to test the key pad/console and troubleshooting info. Disconnect the power supply from the dishwasher before servicing.

Read More
Joey S -
Sears Technician
January 18, 2013
A:

Joey S. Can you make the information bigger so it can be printed and read for the key pad/console and troubleshooting info? I copied it but sure cannot read it when it is enlarged... Thanks.

Read More
Rob -
October 11, 2015
See more answers
Q:

Dirty Filter and Dishes not Getting very clean 66513442K901 Kenmore Undercounter dishwasher

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your dishwasher is not cleaning the dishes.

 I do see that you are able to replace the pump filter, but you will need to take the pump apart. When taking the pump apart you will need to replace the pump gasket anytime the pump assembly is removed from the dishwasher. Also you will need to purchase the pump centering tool to re-assemble the pump. 

303918 tool
 717000gasket
3384593 pump filter.  


It may be cost effective to purchase the complete pump because it comes put together and the gasket comes with it.
W10428780  complete pump. 

To get to the filter you will need to remove the screws on top of the pump. This will then give you access to the wash impeller and screw. You will then need to remove that and this shoudl give you access to the filter.

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
June 08, 2015
A:

Hi and thanks for your detailed response. But specifically I'm curious about the Pump Filter. I was able to take everything apart without any problem. But I could tell there was dirt and grime inside the filter. Once I've taken the filter out of the machine, can I open it to fully clean it out? Or is it built in one-piece so that I need to buy a new filter?

Read More
matt -
June 08, 2015
See more answers
Q:

My dishwasher is not filling up water? 66513442K901 Kenmore Undercounter dishwasher

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore dishwasher.  

From the information you have provided above, I would suggest replacing the water inlet valve. To me it seems like the valve isn’t opening up and allowing the water to enter the dishwasher. The part number for the water valve is W10219643. I would also check the line that runs to the valve to make sure there’s no clogs or anything blocking it.  

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day. 

Read More
Benny23 -
Sears Technician
January 14, 2015

Top Parts