Model #66513423K700 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump, Washarm And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Clean light is blinking.

A:

Thank you for your question.  I am sorry for the problem with your Kenmore 665.13423k700 Dishwasher.  On this particular dishwasher the Clean light flashing does not mean there is a water heat problem and it does not reset the control as others did in the past.  The clean light will blink out the error code so you have to count the blinks.  The image below contains more information on this problem.  You must count the blinks, wait for it to pause 2 secounds then count the blinks again.  For instance the clean light blikning 6 times, followed by a 2 second pause before it blinks 1 time would indicate a slow drain is the problem.  7 blinks, 2 secound pause then 1 blink indicates a water heating problem.  I hope this helps.  You can reply below with any additional details or questions for further assistance. 

Read More
Fred M -
Sears Technician
August 26, 2013
A:

Thank you. It blinks once, waits about 5 sec then blinks 6. That is a slow drain?

Read More
Mary -
August 26, 2013
A:

That code may not be correct. There is a 1-1 code indicating a control problem but that woule be rare. There is no 1-6 code. There is a 6-1 code which indicates a problem with the door switch. The image below contains a list of some codes you might see. Try it again and see if you get the same results.

Read More
Fred M -
Sears Technician
August 28, 2013
See more answers

Top Parts