Model #66513239K700 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

How do you change the gasket on the fill & overfill on my kenmore elite dishwasher?

A:

To access the water inlet assembly gasket place a flat blade screwdriver in the slot of the bezel & force counter clockwise with a hammer. If the air/fill inlet assembly needs replaced the part number is 675828 & comes with the gasket. Please see the images provided below. You may also need to replace the float assembly if it is leaking; 8540224, 9741998, 9743070 www.searspartsdirect.com

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
May 20, 2010
A:

My kenmore elite model # 66513239k700 is leaking from the water level float. It leaks about 1 cup usually towards the end of the cycle. I am not sure if the gasket is leaking or there is too much water in the tank. Too much water may be from not water exiting the machine so the overfill is releasing from the overfill. ANY SUGGESTIONS?

Read More
Dean -
June 06, 2010
See more answers

Top Parts