Model #66513129K700 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump, Washarm And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

I have a Kenmore Elite dishwasher, model# 66513129K700. How do remove the old top rack and install a new one (part W10082823)?

A:

Replacing a rack on a dishwasher could be difficult without the proper instructions. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
November 11, 2012
A:

The new rack may come with instructions but to remove the upper rack you need to remove the plastic stop from the front of the rail. The image below may help you with this. Squeeze the tab in the middle and pull the stop up and out. I hope this helps.

Read More
Fred M -
Sears Technician
November 12, 2012
See more answers
Q:

I need a installation sheet for a Whirlpool dishwasher for a top drawer install.

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide a little more information such as the make and complete model number of your product so your expert will be able to provide you the best possible answer. Just click on reply below where you can provide the additional information.

Read More
Alina F. -
November 17, 2011
A:

We will gladly assist you with installing the top drawer on your dishwasher. To do so, please respond to this thread with the complete model number of your dishwasher and more detail.

Read More
Korinna S -
Sears Technician
November 18, 2011
A:

model 66513129k700, top drawer installation

Read More
karen -
November 11, 2012
See more answers
Q:

My model 66513129K700 MODEL dishwasher purchased in 2009 is leaking sporadically at the end of the smartwash cycle.

A:

A dishwasher can save time and energy or it can ruin our day when it is leaking. While you are waiting on an expert to answer your question, I found a great link in the Manage My Life website on your problem. You can also set service with a Sears technician. I have attached the links below. Hope this helps!

Read More
Dezeray -
September 24, 2012
A:

Thank you for your question and I understand your concern.

If there was a hole it would leak anytime any cycle is used. Based on your intermittent leak I suspect a dish or pan is likely sitting at the perfect angle to cause water to redirect towards the lower front edge of the tub causing water to splash over and run down onto the floor. Now, if the leak is emitting from under the tub, then it could be several different areas or components leaking. Since the leak is intermittent, it will be difficult to locate the source or cause of the leak.

The only thing you can do is to remove the lower access panel and then operate the dishwasher and watch for source of the leak.

Read More
Joey S -
Sears Technician
September 26, 2012
A:

Why doesn't this happen at any other time during the cycle then? It only happens towards the end of the smartwash cycle?

Read More
Barbara -
September 26, 2012
A:

Barbara: The Smart wash cycle is basically the same as the normal cycle. Now, if the leak is emitting from underneath the wash pump, then it could have a seal leaking from the diverter valve but then again, it would likely leak constantly when washing. I added an image below of the different cycle operations. You will see there are not much if any differences between smart wash and regular cycles. When you use the smart wash, are placing any cookie sheets on the side where the water enters? If so, you should place large cookie sheets on the other side.

Read More
Joey S -
Sears Technician
September 26, 2012
A:

Enter replyhttp://www.managemylife.com/mmh/user_profile/2200706891/barbaraS Where does the water enter the tub so I can be sure I don't have anything in the wrong place? The thing is I've been using this dishwasher for a few years and don't understand why it would happen last December and then in August again. So maybe I have placed things wrong......I just don't know how I did that because I think I've always loaded it the same way and I don't put cookie sheets in there.If the diverter valve is leaking, how do we assess that?

Read More
Barbara -
September 26, 2012
A:

Barbara: The diverter is located under the tub near the center and there is really no room to access it without pulling the dishwasher out and laying it on its back. I strongly suggest calling a service technician to repair your dishwasher. The water enters on the left side just the left of the lower rack. If cooking sheet or pot or pan is lying up against the side of the tub, it could cause water to back up and leak on the floor from the inlet assembly. I added a couple image below to reference.

Read More
Joey S -
Sears Technician
September 26, 2012
A:

I have had a technician out twice. In December he said it was the gasket which had some gook on it. So we cleaned it off and it never happened again until August and once again in September. The next technician said it could be a pinhole tub leak or a drain hose leak. There is no indication under the dishwasher of any leakage. When the dishwasher has leaked I find the water in a puddle on the floor in the front on the left side.

Read More
Barbara -
September 26, 2012
A:

Barbara: I recommend calling a service technician if your not able to locate the leak. An intermittent leak is near impossible to locate.

Read More
Joey S -
Sears Technician
September 26, 2012
See more answers

Top Parts