Model #66513119K700 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

White film on dishes.

A:

Hi Ted, Dishwashers are a wonderful invention but not if you have to rewash the dishes by hand. I looked into this and found a post by an expert that seems to fit the problem. I attached the link below. Hope this helps!

Read More
Barbara H. -
June 20, 2010
A:

This film can be caused by two things. One is soap residue and the other is mineral residue.

To determine which film it is can be determined with a simple test. Take a glass with film on it and run it under the faucet with water and use your thumb to rub the film. Dry the glass completely and check if the film is still there.

Soap film will wash off easily and if the glass is clean then the film is soap suds. The problem from too much soap can be caused by multiple things. A poor drain, not enough water, too much rinse agent or the water is not hot enough. These are things that can be checked and repaired.

This can be solved easily with white vinegar. Load your dishwasher up with the dishes that have a film on them and start a rinse only cycle. After the unit fills and starts to wash pause the unit and open the door. Add a cup of white vinegar and finish the rinse cycle. This will clean off any mineral deposits and the glasses will be clean with no film.

The dispenser cup lid is actuated by a duel wax motor assembly when voltage is supplied by the electronic control board. The dual wax motor heats up and the plunger should slowly extend to trip the latch. The dual wax motor will need to be tested for continuity with a volt/ohm meter. The wax motor should have a resistance reading of 600-1800 ohms of resistance.

Read More
Rgabriella02 -
Sears Technician
June 21, 2010
A:

ty ill try that

Read More
daniel noll -
September 21, 2012
A:

Both prolbems (Poor wash upper rack and soap stays in cup) can be due to poor water circulation. MOST of the time this is due to a clogged pump inlet just above the choper. Look down through the holes under the spray-arm into the sump, you should be able to see the clog if that is the issue.

Read More
Chat in RI -
September 22, 2012
See more answers
Q:

Can lime or calcium build up cause Kenmore Elite ultra wash dishwasher, model number 665.13119K700, not to clean the dishes?

A:

In reference to your Kenmore Elite dishwasher, model number 665.13119k700:

If hard water is present, more detergent is needed to hold the minerals in suspension and leave enough cleaning agents to get the dishes clean.

Caution : Do not use too much detergent as oversudsing may occur. Refer to the Picture below or Use and Care Guide to determine how much detergent should be used for hard water conditions.

Note: If extremely hard water is present, a water softener would be recommended. A water sample can be taken the nearest Sears store, in a clean jar, to have the hardness tested or call the local water company for water hardness data

To reduce the build up of minerals inside the tub, use a hard water cleaner like Dishwasher Magic every month to remove any stains and build up. Make sure to follow the manufacturer's directions when using this type of product. To order Dishwasher Magic call our Parts Direct department at 1-800-573-6456. The part number for Dishwasher Magic is WX10X10200. You can also order diswasher magic through our parts direct web site: www.searspartsdirect.com

Read More
Angela R. - Personal Solutions Manager -
Sears Technician
October 08, 2009

Top Parts