Model #66513113K700 KENMORE ELITE Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

removing and cleaning filter in dishwasher 66513113K700 Kenmore Elite Dishwasher

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your dishwasher. Upon researching model 66513113K700; to start unplug the dishwasher power cord, remove the racks inside the unit and remove the lower spray arm. With the lower spray arm you will have access to the sump base under the lower spray arm, remove the 4 screws that secure the accumulator assembly to the sump. Once the screws are removed you can lift the accumulator assembly that has the filter screen built in to it.

 

I trust this information will help you, we appreciate your business thank for choosing Sears.

 

Read More
CarlosZ -
Sears Technician
June 09, 2015
Q:

Leaking Kenmore Dishwasher near float assembly

A:

I understand how frustrating it can be with the dishwasher leaking. I have done some research on the Manage My Life website and ave located a link similar to your issue. While you are waiting for a detailed reply from an expert I have provided the link below. Hope this helps!

Read More
Priscilla V -
May 22, 2012
A:

That gasket at the bottom of the shaft could be leaking. You can pull that float up and out of the shaft. It will have some resistance. It will snap out of the shaft when pulled carefully and firmly straight up. Once you pull that float out, you can examine the nut and the gasket at the bottom of that shaft inside the tub. If the nut is just loose, then you can carefully tighten it and see if that fixes your problem. If not, then you may need to replace the gasket seal or other components. You can order parts from this page: Fill, Drain and Overfill Parts for Kenmore Dishwasher 665.13113K700 .

These tips may help you resolve that leak in your dishwasher. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician examine the dishwasher and repair that leak, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 23, 2012
A:

Lyle, Thanks for the detailed instructions. I will check it out. I have some additional information that may help. I ran the dishwasher again last night with a tray to catch the leaking water and it was dry in the AM. If this is a gasket issue, would it likely be consistent? Does this inconsistency narrow down the possible causes? Thanks. Bill

Read More
William -
May 24, 2012
A:

Hello William. You are correct that a leak in that gasket or the tub would normally be consistent. Since this is an intermittent problem, you probably don't need to check that gasket. Since this is an HE (High Efficiency) dishwasher, the water level does not normally reach a point where a wave action would slosh over the top of that float stem. It may be worth checking that water level periodically to see if the dishwasher is filling to an abnormally high level. The image below shows the proper water level for this model of dishwasher. I recommend that you check that issue. If the water level is too high at times, you could experience an intermittent leak through that float stem if you also have a wave action being created in the tub. A number of different issues could cause a wave action in the tub. You could have a blocked spray arm that is not rotating. A crack or split spray arm could also cause a wave action. Improper loading of the dishes could also cause that problem. I hope that this additional information helps. Based on the latest details, checking those issues may be a better approach.

Read More
Lyle W -
Sears Technician
May 24, 2012
A:

Lyle, Thanks again for your feedback. Having run the dishwasher a few times since then the inconsistencies continue. One day it ran dry, another day perhaps a 1/4 cup of liquid was collected. I think it seemed like much more at first since the lower front cover was on, some of the sound insulation was soaking it up and there was no easy way for it to dry. It sounds like the next best step is to verify the water level is correct mid-cycle. The picture that you sent is not my particular model so I'm not sure what to look for. Any guidelines for what is the acceptable range for water level and what part of the cycle to check for this? Thanks again, Bill

Read More
William -
May 29, 2012
A:

I apologize. I sent the wrong image regarding that water level. The water level in your model of dishwasher should be within 1/4" to just touching the bottom of the heating element in the tub. That problem with a wave action should still be a valid cause of that leak in that type of dishwasher. When you stop the dishwasher in the middle of the cycle, I recommend that you just crack the door open and allow the spray to settle. Then open the door fully and check the water level. If it is over the top of the heating element, then you could have a problem with the drain function or the fill function in the dishwasher. I hope that this additional information helps. Let us know if you need more assistance,

Read More
Lyle W -
Sears Technician
May 29, 2012
See more answers
Q:

How do I take it apart?

A:

You could try youtube. I used excellent tutorials to disassemble my kenmore dryer.

Read More
Jon -
December 09, 2011
A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
aashe -
December 09, 2011
A:

Service manuals are not yet available to the public.

We do have access to the manuals and we do share at this web site. The images below show how to access the sump of the dishwasher.

I can also provide instructions on replacing the circulation motor if needed.

Remember to turn the power to the dishwasher off first.

Read More
Fred M -
Sears Technician
December 11, 2011
See more answers

Top Parts