Model #65795 SANYO Speakers

  • No Image Available - Wards
    3 Results
Find part by diagram >

Question and Answers

Q:

Generator runs but no power 580.327283

A:

The only parts that I show that are located behind the stator cover are the rectifier (pt 65795GS) and the power module (pt 84132GS). The rectifier looks like a little aluminum piece with 3 spade terminals on it. The power module kind of looks like a little box, though it may just be an open circuit board on your machine. The number that you saw doesn't come up as a good part, but that doesn't mean much as the numbers on the parts do not always translate to a part number since they may be component numbers.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
September 30, 2013
Q:

I have a Craftsman 120-240 volt 8000 watt generator model 580328391. It is only putting out 4.6 volts at the 120 volt outlet and 8.8 in the 220 volt outlet.

A:

The power module sends the dc voltage to the brushes to cause the alternator to generate the proper voltage. The residual magnetism in the rotor causes the alternator to put out the 4.6-8.8 volts. The power module converts the ac voltage to dc and sends it to the brushes, causing the alternator to put out 120-240 volts.

The power module is most likely the problem. The system control board (located in the control panel) could also cause this problem. It is unusual for the system control board to fail in this way.

I would replace the power module. I think that will solve the problem.

Read More
Jimmy K -
Sears Technician
November 16, 2009
A:

hello I'm Jamie I have a 7500 Watt craftsman generator. Model. 580327181 and I put it in shed like a dummy while I was using it and it got hot and quite putting out power to outlets. So I did same thing I took off the cover and everything looked fine except the rectifier pat 65795 was melted and I thought Mabye this was the problem cause everything ebiluututlse looked fine.but after reading what expert is telling u cause I checked outlet on the 110 and it put out 4.5 but the power regulator looked fine its not showing any signs of melting or damage so what do I do?

Read More
Jamie -
July 14, 2012
A:

Jamie: I have the very same problem. Have you received any good answers? Please let me know. Norm

Read More
Norman -
August 26, 2012
See more answers
Q:

I have generator model 580327181.and I put it in a shed while running and it got hot and quite having power at the outlets.so I took cover off of main unit

A:

I understand how frustrating with the generator not working. While you are waiting for a detailed reply from an expert I recommend visiting the Sears parts direct website were you can view a full parts list and diagram of your model. You also may find a direct number to were you can speak with a parts associate in regards to your part. I have provided the link below. Hope this helps!

Read More
Priscilla V -
July 15, 2012
A:

The burnt rectifier is very likely the main problem with the generator. To keep it simple, the rectifier takes the voltage being created by the rotor/stator and levels it out (regulates it) and then distributes it to where it needs to go. Also, the rectifier will send signals (in milliseconds) as to what the power demand is to keep the engine running at the same speed in order to maintain constant power.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
July 17, 2012
See more answers