Model #65731 KENMORE Griddle

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Dryer Manual Model# 86573130-65731

A:

Good afternoon. I was not able to locate any information using the model number you provided. Usually the model number will begin with 110. . See if you can find a model that would coincide with that beginning. If you don't find that model number beginning, let us know if it's a gas or electric dryer. We are very happy to assist you. Get back to us when you can.

Read More
Henry -
September 05, 2012
A:

Thank you for submitting your question. Due to the age of your dryer the manual is no longer available. If the dryer is not heating, there are several components to check to determine what needs to be replaced. The operating thermostat, high limit thermostat, thermal fuse, thermal cut-off, and heating element all add the dryer in heating. The first component to usually fail is the thermal fuse to the unit. In order to verify, you will need an ohms/volt meter to test fuse and other components. You can review the parts diagram for you dryer by clicking here . If you do not feel comfortable performing test or repairing this problem yourself, I recommend scheduling for service. You can schedule for service online with our Sears Home Services team. Please reply back to this thread if you'd like further assistance with this repair. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
September 07, 2012
A:

I checked and the model # does have a 110. in front of the other numbers. I have to wait until the system is back up - down for maintenance. I am comfortable checking with ohms/volt meter - just need to know what to check and where it is. Of course, depending on cost of whatever isn't working - probably buy a new one.

Read More
Salish25 -
September 09, 2012
See more answers
Q:

Dryer not heating

A:

I know how useful the owners manual can be since it carries some great information. I suggest you add to the thread of this question and include the full model number of your dryer so that the expert can provide you with a more detailed answer. I am adding a link below to help you locate the model number. I am also adding a second link in where you can enter the model number and if available the owners manual will pop up. I hope this helps with your manual search while you wait for your expert response.

Read More
Joseph P. -
September 05, 2012
A:

If the dryer will heat in come cycles but will not heat in others then the timer is most likely at fault. I would suggest you check the two circuit breakers powering the dryer. If one trips the dryer might run but would not heat well. I hope this helps. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
September 06, 2012
See more answers
Q:

Power Cord for Lady Kenmore to fit receptacle

A:

I know how important it is to be safe when it comes to electrical wiring. At this time, I was unable to locate information that would be helpful in regards to your question. Your expert will answer within 24 to 48 hours with detailed information. Thank you for using Manage My Life.

Read More
Joseph P. -
January 14, 2012
A:

Hi Nette,

Thank you for submitting a question to Manage My Life.

I am including the instructions for wiring 3 and 4 prong power cords in the image below. If the cords are the same, just wire them according to the way the old cord was wired. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. If I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
January 16, 2012
A:

Hello Landell, Thank you for your reply and images of wiring the cord. My husband has studied the images and feels he can wire the newer cord into the older dryer. He will try this tomorrow as it is later in the day and he does best in the mornings. I will let you know how it goes. Thank you very much again, Nette

Read More
Nette -
January 16, 2012
A:

Hi Nette, Glad I could help. Please keep Manage My Life in mind for all of your do-it-yourself projects. Landell

Read More
Landell -
Sears Technician
January 17, 2012
See more answers