Model #64C COMMODORE Computer

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Model FGUB2642LFL refridgerator.

A:

Now that summer is approaching its time to get this Ice maker fix so you can have nice cold drinks. While you are waiting on an expert to answer your question, I found some great links in the Manage My Life website. I have attached the links below. Have a nice day!

Read More
Dezeray S -
April 14, 2012
A:

That model number that you provided appears to be slightly off. The last letter should probably be a number between 0 and 6 instead of the letter "L". Based on the model FGUB2642LF1, that refrigerator appears to have the ice maker with a separate evaporator in the section of the refrigerator. You should see metallic fingers that stick down into the ice mold. I provided a wiring schematic for that model FGUB2642LF1 in the image below. That system is difficult to diagnose and repair. If the expansion valve or the sealed system in that ice maker is bad, then a service technician will need to complete that repair since it involves the recovery and recharging of the refrigerant (Freon). In this situation, I recommend that you have a service technician diagnose and repair the refrigerator. You can schedule service through this link: Sears Home Services .

If you want to try and diagnose this problem yourself and repair the failure (except for a sealed system failure) then you can reply to this thread with an updated model number. The refrigerator should have diagnostic tests on the control that will check the sensor and other loads to help you determine the cause of your problem.

Read More
Lyle W -
Sears Technician
April 16, 2012
A:

Sorry, you are correct. Should be FGUB2642LF1. After some more troubleshooting the freezer and frig sides are the correct temp. The ice maker in the frig is only 56 degrees Farenheight. There is also very little air flowing into the ice maker compartment.

Read More
Frank -
April 16, 2012
A:

Thanks Frank. The first 3 images below show some diagnostic tests that you can conduct from the control. The 4th image shows a troubleshooting for chart for the ice maker problem that you seem to be describing. This information may help you further test that system to determine the cause of your problem. Let me know if you need more help.

Read More
Lyle W -
Sears Technician
April 17, 2012
A:

Here is the 4th image.

Read More
Lyle W -
Sears Technician
April 17, 2012
A:

Thanks for the leads....Will let you know the results

Read More
Frank -
April 17, 2012
A:

The results are in.... All passed except 59C Fill limit switch 60C freeze limit 62C EEV test - Display does not flash and temp stays at 54 degrees 64C indicates the software ver is 80 Thanks

Read More
Frank -
April 18, 2012
A:

Try running that diagnostic test again. That EEV valve test has been known to fail the first test but pass on subsequent tried. See if the fingers are getting cold when the EEV test is in progress. Based on the results of those tests, you may have a wiring connection problem with those components. I recommend that you check the wiring connections on the control board and on those components. Let me know what you find after making those checks.

Read More
Lyle W -
Sears Technician
April 18, 2012
A:

Ran the diagnostic test again and got the same results except the temp on step 62C was 56 degrees. Checked all electrical connections and could find nothing. A control board by chance? Which one? thanks

Read More
Frank -
April 20, 2012
A:

I can't determine whether replacing a control board in the refrigerator will fix your ice maker problem. There are too many factors that can prevent that ice maker from working. If the refrigerator is in recovery mode for an extended period of time, then it will not make ice. If I had to guess which board that you would need to replace (if the failure is caused by a control board), it would probably be the ice maker control board (part 241956703). I don't believe that the original control board is available just by itself. There is an upgraded control board available (part 5303918495). That kit has several upgrades included with the new control board. It does not appear to be available through the Sears PartsDirect parts source. You can try a web search to find that control board kit. I added a link below for one source that appears to have it. Replacing that control board and installing that kit may or may not fix this problem. If you need more help, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
April 20, 2012
See more answers