Model #6461099 CRAFTSMAN Buffer/polisher

  • Buffer/polisher System
    3 Results
Find part by diagram >

Question and Answers

Q:

glue for pad for Craftsman buffer/polisher

A:

I am understanding your issue that you are having withe the polisher pads. I was able to find the Owner's Manual for you and i am sure it might help you.

Read More
celene -
February 14, 2011
A:

Thank you for your question.

I can understand wanting to replace the pad on the buffer.

If I remember correctly it should have a white side and a gray side.

The white side is the side you put the adhesive on.

I used a product called 3M 77 spray contact adhesive.

Spray both sides of the two contact surfaces and let set for a few minutes and then apply the two together.

Be very sure that you have it centered on the drive plate or it will vibrate even worse than it normally does. I would set the platen onto the dry pad and get it centered and then draw a line on the pad so you know where to set the platen when you have the adhesive on both surfaces and you are going to apply then to each other.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 15, 2011
A:

After joining the two pieces do you apply pressure for the suggested hour to assure a good seal?

Read More
Bruce Martin -
June 18, 2012
A:

It is a Craftsman Buffer/Polisher Model # 646.1099, and the Pad is Part #41P27401 which is a sub. for Part Pad3018

Read More
Hubert -
June 20, 2012
A:

Thank you for the update on the pad polisher. Yes, it may be a good idea to wait for the adhesive to set up in this situation. Sam A.

Read More
Sam A -
Sears Technician
June 25, 2012
A:

I have the Owners Manual that came with the buffer, and there is nothing in it about the adhesive. The way the back plate to shaped I so not think that I will be able to get the plate into the Foam Pad because the plate has a U shape and was glued on the flat surface and the vertical edges. I think the sides will grab before I can get the plate inserted into the Foam. Any Ideas?

Read More
Hubert -
June 25, 2012
A:

Thank you for the update on attaching the foam pad to the old drive plate. I am sorry but I did not think any of the adhesive was on the sides of the foam pad, or did I misunderstand what you said. When I replaced mine I bowed the foam up on the sides so I could see that I was putting the foam onto the center of the drive plate pad and then let the sides down and set the adhesive. Sam A.

Read More
Sam A -
Sears Technician
June 25, 2012
A:

Sam A., I am the one with the Craftsman Buffer/Polisher Model # 646.1099. I have the 3M 77 adhesive and need to know after I spray the adhesive on the plate and replacement pad/wait for it set do I have to apply pressure to assure a good seal?

Read More
Bruce Martin -
June 25, 2012
A:

Sam A., I misidentified the model number, it should be Craftsman Buffer/Polisher System, model #646.10702. I am ready to attach the pad to the plate but wondered if I would have to apply pressure, while the adhesive sets, after joining the two parts together?

Read More
Bruce Martin -
June 25, 2012
A:

Thank you for the update Bruce. Contact cement is just that, it should be done a soon and you put the two surfaces together and it should not require pressure. Sam A.

Read More
Sam A -
Sears Technician
June 26, 2012
See more answers