Model #64208 KENMORE Patio Cover

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers


clothes still wet after spin TAWX700JQ2 Estate Residential washer

A: is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using!

Read More
Barbara -
April 27, 2013

Thank you for submitting your question. I understand your concern and I will be happy to assist you. If the washer will spin out a small load fine but large loads are wet,then the problem may be with the clutch (285785) for your washer. The clutch is made to slip at the beginning of the spin cycle. This allows the basket to slowly come up to speed. When the clutch wears out the basket will not come up to speed with a large load. To diagnose this failure, you would need to pull off the washer cabinet and pull the transmission down. You'll likely find the clutch band glazed over. The would indicate that the clutch is not exerting enough torque to release the brake and allow the washer to spin at the proper speed. The images below will assist you in this repair. If the clutch is good, the other parts that would cause this issue are the transmission (3360629), basket drive (64208), and/or drive block (389140). You can order parts from our Sears Parts Direct web site. I hope this helps. Please reply back to this thread if you require further assistance. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
April 29, 2013
See more answers