Model #6401 BROWER Poultry Equipment

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

My Hoover u6401-9rm vacuum is loose so the belt slips unless the handle is all the way to the floor.

A:

I understand that you want to remove the front part of your vacuum to be able to tighten your belt. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful.

Read More
Alina F. -
February 11, 2011
A:

Thank you for your question.

I can understand why you are wondering you have to let the handle all the way down to get it to work.

The unit have a belt tighter arm and either the belt is really stretched or the idler arm has a problem.

  • Flip the vacuum over and remove the 4 screws on the sole plate and then remove the sole and remove the roller brush.

Remove the two knobs on the front cover. They just pull off.

  • Then locate the two screws under the roller brush and remove to take the top cover off.

  • This should release the front of the cover and the back should have a plastic tab on each side to release the top cover.

  • Once you have the cover off then locate the idler arm that tightens the belt when you tip the handle back.

It may be just a belt or it could be the idler arm and or idler bearings on the idler assembly. You really will not know for sure until you can get it apart.

I hope this helps. I was not able to find a service manual for this model.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 14, 2011
See more answers
Q:

My GE Cooktop Mdl JGP 640/1 igniters will not ignite (tick) if i use 1 burner for 1 hour unless I let the unit cool down completely.

A:

Having a Cook Top can working properly can get very frustrating especially when trying to cook. While you are waiting on an expert to answer your question, A suggestion I have is to visit Sears Home Services website to set service with a Sears technician. I attached the link below. Hope this helps! www.searshomeservices.com

Read More
Dezeray S -
November 09, 2010
A:

From what you're describing it sounds like the spark module needs replaced. The spark module is under the cooktop surface on the left hand side. This type of diagnosis & repair should be done by a trained technician. The cooktop will have to be uninstalled, completely. This will include removing the downdraft vent assembly. I recommend calling for service.

Here is a link for the website: Sears Home Services .

Another possibility is a wiring harness problem, usually at the spark module.

Please see the attachment below.

Read More
biker dave -
Sears Technician
November 10, 2010
See more answers
Q:

How do I replace the igniter on my GE cooktop?

A:

The igniter has a clip on the bottom that has to be accessed first. You will need to pull the cooktop out & turn it over & remove the burner box in order to access the igniter clip. Please see the image provided for instructions.

Be sure turn the gas off & disconnect power before attempting removal.

Read More
biker dave -
Sears Technician
December 09, 2009
A:

We just purchased a 15year old home and it has a GE gas cooktop Mdl JGP640. when you start to cook, all of the burners will ignite when asked to, but if you start to cook with one burner on low for approximately 45 minutes and try to start another burner, the spark does not work on any burner until you let the unit cool down for a couple hours. Do you have any suggestions?

Read More
bruce -
November 09, 2010
See more answers