Model #63016309403 KENMORE ELITE Dishwasher

  • Control Panel
    3 Results
  • Front Door
    3 Results
  • Cabinet Assy
    3 Results
  • Pump Assy
    3 Results
  • Base Assy
    3 Results
  • Rack Assy
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Fills with water, but won't start the wash cycle 63016309403 Kenmore Elite Dishwasher

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

I would recommend replacing the control board. It sounds like it’s not sending the proper signal with the bad leads you were talking about. The only way to get this dishwasher going again would be to replace that control board.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

 

Read More
Samantha A -
Sears Technician
November 26, 2014
A:

Unfortunately a replacement board has not fixed the issue. Again, the only thing that the unit doesn't seem to do right now is send the water through the arms. Does the same pump in this unit that drains the water also spin the arms? Is there a repair manual or advance technical guide available for this unit?

Read More
Jason -
December 02, 2014
See more answers
Q:

Kenmore Elite dishwasher water not circulating

A:

Dishwashers are wonderful inventions but can give you the yuck factor if they are not cleaning the dishes. While you wait for the expert answer for your model, you can check a expert suggestion from a previous similar post. Bear in mind the model number is different. I also added a troubleshooting guide that may help. I attached the links below.

Read More
Barbara H. -
December 03, 2010
A:

From the description you give you hear the circulation motor humming but it doesn't turn.

The pump may be blocked or just bad. The circulation motor can be removed and obstructions checked but it is a difficult do-it-yourself.

To access and remove the motor you will have to remove the toe panel and the right hand side panel. The dishwasher will have to be pulled out from under the cabinet.

Unless you are extremely confident in your do-it-yourself skills I'd suggest a technician check and repair this problem.

The image below will show the steps to accessing the circulation motor. There are many steps and it is a difficult job. Read through the instructions first.

Remember to turn the power off first.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears�s technician. Here is a link for the website: Sears Home Services .

If you do-it-yourself and find the pump is bad then it can be obtained from the following link: Sears PartsDirect .

I hope this information is helpful to you in resolving this problem in time for the holidays. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
December 04, 2010
See more answers

Top Parts