Model #6284588090 KENMORE Ranges, Electric

  • Control Panel And Cover
    3 Results
  • Main Top Cook Surface
    3 Results
  • Body Assembly
    3 Results
  • Door And Latch Mechanism
    3 Results
  • Wiring And Wiring Terminals
    3 Results
  • Optional Steak Grill Kit
    3 Results
  • Optional Griddle Kit
    3 Results
  • Optional Roti/shish Kit
    3 Results
  • Optional Cutting Board Kit
    3 Results
Find part by diagram >

Question and Answers

Q:

Remove end cap to get to control panel 6284588090 Kenmore Kenmore electric range

A:

Thank you for your question and I understand your concern.
 
I can understand how frustrated you must feel and I will send you a diagram below from www.SearsPartsDirect.com  The right endcap has a screw at the top and one screw at the bottom as shown in the parts diagram. Most likely these are torx screws or Phillips. You will need to remove the bottom rail and most likely the top rail too. We do not have any service manuals for this model range with any step by step instructions.
 
I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
September 24, 2013
Q:

Clock shorting out when I turn on oven. Burners work fine. 6284588090 Kenmore Kenmore electric range

A:

Thank you for your question and I understand your concern.

Rather than attempting to wire around the clock assembly, why not repair the Red broken/burnt wire connection? I strongly recommend looking for the wiring schematic on the range. I added a picture of the wiring diagram taken from a micro fiche card that may be helpful if you cannot find the wiring diagram on the range. 

The clock can be wired around using the wiring diagram. If you do not feel confident in doing so, I strongly suggest calling a service technician. 

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
September 23, 2013
A:

Joey, thanks for your help. I do not see an attachment. (wiring diagram). I would love to see a wiring schematic. I purchased the cottage and they did not leave the manual and I could not locate manual on Sears web site. The only reason I did not want to replace the red wire is, over the years the clock slowly got noisy due to vibration. Once the clock stopped working, the noise stopped. Being a cottage, I did not see the need to replace the clock. If I decide I do not want to fix the clock due to the noise of the clock. Is there any reason to remove all wires from the clock. Or just leave wires alone? I'm 99% sure the only issue was the broken red wire was live and touching metal. Thanks Bob

Read More
Robert -
September 23, 2013
A:

Robert: You will need to leave the wires connected to the clock because it has a start and stop time knob. Generally speaking, the start knob is usually pushed in for manual operation. Replair the red wire and the oven should work as usual. In order to see the fische copy of the wiring diagram, copy and paste the URL below in your browser and it will take you to the Manage My Life web site. http://www.managemylife.com/mmh/questions/361651-clock-shorting-turn-oven-burners-work-fine-6284588090-kenmore-kenmore-electric-range

Read More
Joey S -
Sears Technician
September 23, 2013
See more answers