Model #625348491 KENMORE Water softener

  • Softener Assembly
    3 Results
  • Brine Valve Assembly
    3 Results
  • Valve Assembly
    3 Results
  • Bypass Installation Valve
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

leaking where the clip attaches the bypass assembley 625.348491

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your water softener and I do understand your frustration. Glad to help out. I'm looking at your model number 625.348491 and the o-ring that you replaced is the only part that keeps the unit from leaking at the outlet. If it is still leaking after you replaced it, then the valve body is cracked and needs to be replaced. If you don't feel comfortable doing this yourself I recommend contacting a service technician. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
January 15, 2015
A:

Is this a fixable problem, or something that we should just live with? From everything I've read, this is a known issue, and throwing parts it does not resolve the issue.. After replacing the Valve body, my 625.348491 water softener still has a annoying leak at the valve intake side. Here is a interesting post, that describes the issue: http://www.softenerparts.com/kb_results.asp?ID=76

Read More
Shannon -
December 09, 2015
See more answers
Q:

Isn't it wrong to connect a softener drain fitting to a copper wall drain tube with a rubber tub? 625.348491

A:

Here's an installation guide for a newer model of Kenmore water softener that has more details than the manual for your specific model. Page 7 of that manual shows the drain tube recommendations. There should be an air gap in that drain tube installation. The bypass valve information is also shown in the manual.

I hope that this information helps. If you need further assistance, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
April 20, 2015
Q:

How do I determine the "service position" for the valve cam and gear 625348491 Kenmore Kenmore demand water softener

A:

Page 21 of your owner's manual shows how to set the valve to the service position and shows the valve position markers. Here's a direct link for your owner's manual: Kenmore Water Softener Owner's Manual. Refer to the procedure and diagram on page 21 to set the valve to the service position and verify that the valve is actually in the service position.

I hope that this information helps. If you need further assistance, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
April 09, 2015

Top Parts